Search results for query: *

Promise to look out for replacement. The Newport is my summer daily driver, but I find running a car daily gives me more regular input on it's status, than a car I only take out of storage occassionaly. Frequent usage combined with good servicing is not bad, even for old card. Not saying that my...

An oversize cup will not pass the entry of the hub, since that has not been "rotated"/grinded to oversize. The entry has original size, so to be able to mount an oversize cup, I would still need to mill the hub oversize. But doing that, a bearing with oversize outer diameter would be easier than...

Future will tell. Though I doubt it will happen neither overnight or instantly. And I am not sure that sheet metal firmly squeezed between milled cast iron (hub) and milled forged steel (bearing cup) with no room to expand is so soft. If there were room to expand, sure.

I have had problems with my front right wheel bearings for some time. I hade them swapped at a garage 2 years ago, but during this summer I identified a front end rumble to be a too loose front bearing. So I adjusted, thinking that the garage had done a poor job. A week later, same thing. And...