1965 New Yorker Sedan cleanup

Two things you can do to eleiminate stalling in regards to the lighting system..
1) Run a wire with a fusible link from the battery stud back of alternator to the battery stud of starter relay.
This takes 50% of the load away from the ammeter gauge.
2) install the following headlamp harness with relays.Totally eliminates dimming of lights and take the draw away from the foot switch and headlight switch.
Plug and play no cutting or hacking of original wiring. Tape up the original right low beam plug it will no longer be needed.
Replacement relays are generic and can be bought anywhere.
Available on Amazon dot com
View attachment 364309

Cbarge.... I'm very interested in this set up. Where do you get it? You posted a pic, with no other info.

I did the wire to alt already... thanks! Great suggestion. It makes a huge difference. Nice to know I'm not pushing that much amperage through the firewall anymore.

Thanks,

JR
 
A small update, I got a new Offenhauser intake and a Super Bee 3.23 (489 #9 case) rear differential. The Holley carb that was on the car when I got it fits the Offy, so I will try this combo out while rebuilding the original Carter.

I have new tires ready to swap on, but I'll take a double rear tire burnout video before taking the originals off. They are pretty worn so I'll give them a Viking Funeral.

received_1205290359811179.jpeg


received_533581123994798.jpeg


received_238747733883624.jpeg


received_254989405705109.jpeg


received_1117586161951260.jpeg


received_337386797236657.jpeg


received_240294837188449.jpeg
 
So the intake I posted above was labeled as being for an RV block, but it's really for a 383, so it had to go back.

I found the correct Offy intake and also fell into a QFT 750 with nice metering blocks and a pretty cool secondary setup. No choke. The QFT fuel hose is a cool polished fitting with braided stainless flexible hose. This inspired me to use more braided hose through the engine bay.

Also came into a set of original Cal Custom valve covers. I found a PCV breather setup that would fit (Spectre 4290) and installed this.

Rerouted the coolant lines over to the wheel well. I am working on some stainless clamps or brackets to hold these in place.

Also wired in new headlights that have the option for halos for daytime running lights. I love the look of halos behind the decorative glass, a really cool visual effect.

20200703_230337.jpg


20200902_215041.jpg


20200902_214643.jpg
 
I got those nice stainless ARP bolts all over, and ordered some vintage 1960s thumbscrew hose clamps to add a nice finishing touch on the stainless lines
 
What a GREAT car! I noticed your front license plate frame says IVERSEN. There was a Chrysler dealer here in my city called Iversen motor company. I wonder if it got traded in and resold there? Really neat!
 
What a GREAT car! I noticed your front license plate frame says IVERSEN. There was a Chrysler dealer here in my city called Iversen motor company. I wonder if it got traded in and resold there? Really neat!

It was serviced there at one point and they put the frames on.

If you want them, they are available! I replaced them and put them away
 
Back
Top