Recent content by 72 Furyguy

No one around here seems to be able to get a pitman arm for my fury....I could use some help...I have a moog number because I called federal mogul...K 7072. Any cross reference or other manufacturer part numbers would help..thanks:BangHead::BangHead:

the float fell off the sending unit

Autozone had no listing..........The one from Summit worked perfect!!!! My gauge lives again!!!

Does anyone know where I can get a sending unit for my 1972 Plymouth fury....no one around here seems to list one. I called around....NOTHING!! THANKS

Im paying attention....dotting the I ...crossing the T. Firing order correct...18436572...same as gm. Number one TDC and followed the rest. I re gapped the points...checked lobe cam...coil connections...and then found the problem....READY FOR THIS?????...either it was like this before or when I...

Is there an EARTH wire....because I don't see one.

the car started and will idle now...but has no power...very very flat....timing is 10 deg....21 inches of vac...checked for vac leaks just to double check...and car still runs flat as a pancake. I get a lot of black smoke when I add throttle....played with the timing to see if it would settle...

all the other tune up stuff was done last week...only points were done yest. that's the only damn thing I touched...It started and ran a couple of min just now and of course...DIED. im ready to put the old ones back in...lol. all vac lines are fine..i plugged the one to the air cleaner just to...

the car wont stay running long enough for me to get to the meter to see it...as soon as I let off the gas....it dies

that's not helping me with the current issue....I want to know what Im doing wrong....its called and education.....this shouldn't be happening....there has to be an answer. I can convert later.

Ok...so I have a problem....I decided to put new points in the fury....new coil...plugs...wires...cap...rotor all done already and no problems for at least a week....then yesterday I decided to change points and condenser just to have new stuff....old points kinda worn...NOW THE DAMN CAR LOADS...

Ok...so I have a problem....I decided to put new points in the fury.... coil...plugs...wires...cap...rotor all done already and no problems for at least a week....then yesterday I decided to change points and condenser just to have new stuff....old points kinda worn...NOW THE DAMN CAR LOADS...

Its a bench with bucket backrests and fold down armrest.