Recent content by Tony Mopar

Looking for a 1972 Fury 3 - 2 Door projectcar. No showcar, No engine/trans needed but it has to be rustfree - a little rust no problem but no swiss cheese - and no major damage. It must have the hide away headlights. Will be my next projectcar. [email protected]

Just lower the front :)

I was talking about a specific cam: the Hughes Whiplash cam. Its on their website: Our Whiplash cam is designed for basically stock, low compression engines. This cam will run on pump gas in a 440 with 8.25:1 or less compression and iron heads. If your compression is higher than this you may...

Thank you Has2b for your advice! However, when getting the CR above 8.5, the Hughes cam does require other higher octane race fuel. When Im changing pistons, alot more work and money is involved. And I do not have the budget for that unfortunatly. My heads are 975's btw.

Had some feedback from the machineshop regarding the pistons. They used these: Silv-O-Lite Cast Pistons 1276-030

Thank you Stubs for sharing you knowledge! Good point about the thick gaskets! But isnt there an easy way to measure the CR somehow?

Thanx for pointing that out Dave: On my current radiator, the lower hose is on the pass side. On my 440, the waterpump also has it on the pass side. So I got that covered! :)

Thank you Dave for your extensive answer! I do have a total rebuilt and upgraded 727B with the engine and also have the yoke to make a custom/other driveshaft. Im also aware that I probably need a higher stall TC but the engine has my priority now. The Fury has the big radiator already, I have...

Hi Stubs and thank you for your comment. I'm not 100% sure about the compression ratio but according to the machineshop that sold me the engine, its stock low compression. I did not receive a build sheet with the sale, however, on the invoice there were some numbers behind the items they...

Thank you for your answer! The current cam is this one: Sealed Power Replacement Hydraulic Camshafts CS327 Bone stock :)

Hoping to get some info/advice from you about my 440 built, as I can't see the forest anymore because of all those trees..(Dutch saying :) Meaning: There is so much to buy and so much info out there, I kinda lost track on what to do. I recently purchase a 1975, steel crank low compression 440...

PM sent

Looking for a #187 oilpan (or the identical #699) for my 440 engine to fit my 1972 Fury. It has the indent for the pitman arm. Also, looking for the sump that go with it. Please send me a PM if you have one in good condition. Thanx!

Im told that the 1972 tranny mount from the 904 is the same as for the 727B on a 1972 Fury?

Im trying to get that book but untill now, with no succes unfortunatly. But my other book, this forum :), helped me alot. Thanx guys