WANTED White nylon bulkhead connectors

Status
Not open for further replies.

polara10x500

Member
Joined
Jan 26, 2020
Messages
151
Reaction score
132
Location
TN
Feedback: 1 / 0 / 0
Contact seller
For a 69 dodge polara 500 engine bay side. First three from right to left are 8 pin, would like to find these three. On the third from right the lower two connectors seem to be offset a little.
Are these unicorns or what, can't seem to find correct ones anywhere.
 
These are the only ones that I know of that you can buy new:

White Engine Wiring Harness Terminal 1970-74 E-Body 1971-74 B-Body, Harness Accessories, 102-Q3 Reproduction, NOS and Used Mopar Muscle Car Parts
102-Q3.jpg



Wiper Wiring Terminal 1971-74 B-Body 1970-74 E-Body, Harness Accessories, 102-Q4 Reproduction, NOS and Used Mopar Muscle Car Parts
102-Q4.jpg


Headlight Harness Terminal 1971-74 B-Body 1970-74 E-Body, Forward Light Harness B-Body, MP-Q8 Reproduction, NOS and Used Mopar Muscle Car Parts
MP-Q8-1.jpg


Transmission Wiring Terminal for a 1970-74 E-Body 1971-74 B-Body, Bulkhead Connectors, 102-Q5 Reproduction, NOS and Used Mopar Muscle Car Parts
102-Q5.jpg


You'll need to compare them to see if they are the same as a C body. Might be a little tough, as there's only one photo of each connector.

The second one last one are 4 pin connectors. B & E cars only have 4 connectors on the bulkhead, so the third 8 pin connector is probably C body only, and not reproduced, but to be honest, I've never looked for it. I'm aware of these because I just finished up doing electrical work on an E body.


Jeff
 
Last edited:
Thanks Jeff, I've been from one end of the net to the other an have not seen these, its mainly the first two connectors from the right that I need, both 8 terminal, the first one has 1 vertical row of regular openings on the right side then 1 row of larger openings on the left for heavier gauge wire or two wires in some cases. Thanks again.
 
Sorry guys didn't take pics this evening, even though I could type a description of them for you there is no excuse for no pics, I apologize for that. That being said it seems weird to me that even though these connectors look orig. as does the wires and harness to the car, these white connectors are mostly found on 70 an later a b an e body's. Not to mention this one year only black bulkhead connecter that is very distinct in the way it fastens to the firewall and the way the fuse block and harnesses all connect on both sides of firewall. Very easy to tell that all this is original wiring. IDN I'm fubared. I know 69 was a transitional year for C body's but can anybody educate me on this electrical set up on this car. Thanks to all.
 
I have personally seen both white and black on 69 Polaras
My current 69 Polara 500 has white, it is December build

Here is a parts car, 69 Polara with black (connectors seen left edge of picture), Don't recall the build date (early, has wire mesh cowl grill)
2010-01-17_06.jpg


My first 69 Polara, also earlier car, this one with white.
2016-05-15_001.jpg

If it matters I might be able to find the build dates


Alan
 
I'm pretty sure the CHP car had white (5/30 build), when I had a new forward lamp harness made I believed they reused the connector as they didn't have it in white.


Alan
 
Have wire mesh cowl grill, not plastic. Is there a distinction between CHP cars and domestic cars specifically in the bulkhead wiring?
 
Have wire mesh cowl grill, not plastic. Is there a distinction between CHP cars and domestic cars specifically in the bulkhead wiring?
No, the CHP cars were just regular production cars with a few exceptions, this isn't one of them.

Both of the cars I posted are non police package cars.


Alan
 
I will check tomorrow. I should have new ones
New ones would be nice to have, first one from right has two locating ribs on the right side when installed, second has one locating rib on left side when installed IIRC. Will look at again today to be sure I'm correct.
 
Status
Not open for further replies.
Back
Top