Thanks for the tipHaving a 64 myself, you'll get lots of "why's" from other guys and although I haven't done it, custom headers are your best bet. Personally I went with the stainless truck headers and painted them with high heat spray. Warning though, I did have to "machine in" the passenger side to get it to fit.
i have long ram intakes, so those wont work. Besides, they would interfere with the steering box and heater on a 60-64 full size car. I want tube headers. Thanks.
I'm not worried about the heat risers. It's a summer driven car, and will have electric chokes. Will be running 3 inch headpipes and 2 1/2" tailpipes. It's not stock or original.If you have long rams, isn't there supposed to be some ducting from the exhaust manifolds to the bottom of the carb plenums on the intake manifolds? For better cool/frigid weather driveability? What diameter exhaust system is under the car?
Just curious,
CBODY67
Yes, That's pretty much what I'm thinking too. May need some mods
Gotcha, I have long rams on my '66 Newport and run the stock exhaust manifolds with 2 1/2" exhaust pipes.i have long ram intakes, so those wont work. Besides, they would interfere with the steering box and heater on a 60-64 full size car. I want tube headers. Thanks.
Awesome! That's pretty much what I am doing. I just want better flowing exhaust, and so far headers are looking non existant. Left side could use a center dump like a shorty, but passenger side needs the outlet a bit further back. The steering box and control arms on 60-64 bodiesmake headers a bit challengingGotcha, I have long rams on my '66 Newport and run the stock exhaust manifolds with 2 1/2" exhaust pipes.
View attachment 438878
View attachment 438881
Curious as to your engine specs. Cam choice etc. I want a super torquey street only combo with monster low to mid range torque and easy cruising on the highway.Gotcha, I have long rams on my '66 Newport and run the stock exhaust manifolds with 2 1/2" exhaust pipes.
View attachment 438878
View attachment 438881
thanksStock 383 internals with a MoPar Performance "purple shaft" hydraulic flat tapped cam. RPM range is idle to 5800, lift is .450 intake/.475 exhaust. Good vacuum, excellent throttle response and it cruises great.
The part # is P4529270AE
Cloyes double roller timing chain and gears.
Note: when I ran the fuel lines I omitted the rubber at the carb ends. The only rubber is on each side of the OEM style fuel filter. I despise rubber lines on engines. I used the ni-copper tubing, it's really easy to bend and not flatten or kink.thanks