Search results

  1. DuaneBallard

    WANTED Federal pump pulley

    My car is a 66. It's going on one of the classic industries repro pumps. Doesn't matter the style to me as long as it works on the pump. Thanks
  2. DuaneBallard

    WANTED Federal pump pulley

    I'm looking for a federal power steering pump pulley. Press on for 5/8" shaft. Thanks
  3. DuaneBallard

    WANTED 1966 turn signal switch

    Looking for a turn signal switch for my non tilt wheel.66 300. My original is plastic. Thanks
  4. DuaneBallard

    What did you do to your C-body today....

    I finally finished my vintage air install and new interior.
  5. DuaneBallard

    What did you do to your C-body today....

    I made some more progress on the interior yesterday. I wired up the vintage air control panel in the console. Installed the kick panel vents I restored and installed the door panels.
  6. DuaneBallard

    What did you do to your C-body today....

    I continued on the interior of my 66 300. It's finally starting to look likea car again.
  7. DuaneBallard

    1966 300 door window roller

    Okay I see how the old one is in. How in the world does the new one install without the spinning press at the factory to mushroom the head?
  8. DuaneBallard

    What did you do to your C-body today....

    Thank you! I'm really happy with how it came out. First time I've made or installed a bow type headliner. Just carefully used the old stuff as a pattern and followed the manual exactly on how to install it.
  9. DuaneBallard

    What did you do to your C-body today....

    I made and installed a headliner in my 66 300. Also did the visors and started putting all the window trim back in.
  10. DuaneBallard

    66 300 seat foam

    For sure I will.
  11. DuaneBallard

    66 300 seat foam

    I am going to do a little research and I may be trying it. I don't mind doing surgery if it's a good base to go from.
  12. DuaneBallard

    66 300 seat foam

    Does anyone make bucket seat foam for these or has anyone found something from another year that works with modifications? Thanks
  13. DuaneBallard

    What did you do to your C-body today....

    I sewed up a new headliner for the 1966 300.
  14. DuaneBallard

    What did you do to your C-body today....

    My headliner material for the 66 300 arrived. Just need to turn it into a headliner now.
  15. DuaneBallard

    What are you working on today??

    I just put one from them in my 66. Perfect fit.
  16. DuaneBallard

    What are you working on today??

    When you pull the original covers off you can see how it's tucked into the areas for the shafts. I pulled the shafts out so I could clean them up and make it easier to tuck the new material. I cut the binding from the same material wider than needed. After I sewed them I trimmed the excess width...
  17. DuaneBallard

    Getting a emblem repoped?

    I've had a custom badge 3d printed on a project. I printed it in plastic to check the fit. Once that was set I had it printed in stainless and chrome plated. It's the badge on the tank pictured
  18. DuaneBallard

    What are you working on today??

    I pulled the original headliner and insulation out of the 66 300 today. I was able to get the new insulation in before the heat ended the day.
Top