Separate names with a comma.
Lancer was not sold in Canada.
Only Valiant as a stand alone car-not even marketed as a Plymouth.
I am assuming either being a GT it came with...
Only 2838 4dr sedans built for Canadian market in 1966. Not sold in the U.S.
With the Autopact Agreement signed the year before. 1966 last year...
First show this season and....need to make room on the mantle above the fireplace!!!
Your wipers sit a little high.When running the left wiper may go past the glass.
They should be parked resting on the cowl trim.
Gotta love how...
I have done 3 TTi systems,1 on a 440 and 2 on 383 C's.
Love the Dynomax Super Turbo's in the kits.
Unless you are doing a Stroker motor,Leave the...
No ethanol. Period.
It will wreak havoc on small engines and classic cars too.
Shell v power does not contain ehtanol.
Other compNies you can...
Go to a hobby shop and get the finest brush available say like a 00000 brush. Testors flat white works well when well stirred/shaken and it is...
That is what I failed to do. That and all the driving I enjoyed doung last summer Lol!
Had to replace the left side flange gasket on the BoaB.
Not fun with the HP manifolds. Just gratefull that I have access to a hoist on lunch at my...
The trunk spatter paint is a good idea.
Actually I would use it over the undercoating for that crisp clean look.
I see you are running the old mechanical voltage regulator under the hood.
I recommend swapping it out for an electronic one.
Is the motor a fresh rebuild?
If so the idle and vacuum will go up and down and will take about 500 miles to get all internal parts to gel and...
I use original frames and use 18 inch refills.
Nigel at National Moparts has a pile of them,I know since I saw them personally bought a couple....
Get an electronic gauge voltage limiter NOW!
The old bi-metal limiter is going to shit the bed and fry your gauges!
The limiter takes 12 volts...
Is your choke thermostat working? It should pull off after being warmed up.
2bbl 383?? I may have NOS one if needed.
In a perfect world removing the windshield and dash frame is best to access the dash pad.
Otherwise keep the gauze bandages and wrap handy for the...
Typical 68 chrysler issue...headlight switch circuit breaker gets old and trips out.
The harness with relays cures that.
I have spare...
I agree having a FSM is handy. But in this case when you upgrade anything pertaining the ignition (and fuel systems) the FSM is just good bowl...
Yup. Stock cam should get 18 or 20 inches of vacuum. Mild cam should get 15.
383 with Pertronix factory distributor the engine will run and be happy at 11 12 degrees BTDC.
Hope this helps.