Search results

I've got a 360 motor, all original car. Just under the radiator cap there is a small tube that goes straight down and once warm, coolant hits the ground.... I figure the right thing to do is add an overflow tank? How big? Where? Does the type of cap matter? Is it possible I have a bad cap? Thank...

I wasn't getting pinging.. smell seems to have mostly gone... I don't drive it much and keep it in storage so next time I run her I'll do a thorough sniff test. Trying not to be affected by wishful thinking as I was with that valve... :)

I have an update... It's been quite a while. The smell did not go away after all... I hardly drove it because of that, though she got a nice fresh paint job. But I do have great news... Most recently, it occured to me to check the timing. Yeow!! It looked to be at least 20 degrees advanced! I...

Lol

Exactly what I need. Thank you haven't looked since I posted but hoping for the best with those bolts as this has mostly been a dry California experience... About those suspension parts... Do I need to get a fork tool or what's the best way to get those off?

What's the best way to drop the pan without pulling the motor?

Getting that oil pan out without pulling the motor seems like a bit of a challenge.. looks like I might have to remove some suspension pieces or exhaust pipe and at least lift the engine up

Thank you.. is the oil pan and rear seal something that can be done with the engine in the car?

72 Fury 360 auto Transmission needs a rebuild. I've also had to epoxy the bottom of the oil pan due to pinhole leaks and now the rear main has a bad leak. Also have some seepage at the front. Option A: pull motor and trans and replace engine gaskets and freeze plugs and seals. I will have a...

Gentleman,.... Oops!! Yes, the correct bulb is 1895. Pressed for time and trying to squeeze one more thing out of my weekend, I pulled the bulb in the dark and what ended up in my hand looked like a bulb without the metal base. I know some modern bulbs are that way. When I went back to the car...

Can someone please give me the part number for the light bulb that goes in the rear corner side lamp it's a little round bulb.. thank you

Thanks Ben!!

I wonder if it makes a difference... swirls the air? IDK....

Yup... They were fine until I took it all apart... Good now and lesson learned..

Hooray for Dave!!! Thank you for the tip and especially for responding so quickly :) I pulled the carb and sure enough, the plates were not completely closed as in the first pic below... I loosened the screws (notice the brass 6/32 I modified because I lost one!) and moved the shaft back and...

Here's some pics... Going to loosen the screws and see if the plates seat better

Thanks Dave! Pulling it now and gonno put up some pics... trying to beat the rain :)

Car was running pretty good but bogging when I stepped on it. I saw the pump was only squirting into the left horn. Gaskets were toast so I did a rebuild. The only snag was when I dis-assembled the StepUp assemby (with the metering rods), there was a piece of seal or gasket stuck on the spring...

Any color is ok. I'm guessing the size approximately 18x12 flat-ish curved...and a pillar plastic trim would be nice too :)

I could use the plastic piece that makes up the under-dash under the steering wheel...