Search results

  1. Love Shack

    Distributor points screw.....

    Sorry I can’t help. I was to lazy to read your question.
  2. Love Shack

    Last chance

    I also had a similar problem with the pick up coil in the distributor on a later model Mopar of mine (1979)
  3. Love Shack

    Lean Burn Carb Idle Problems-Help Needed

    I have a lean burn set up with a Thermoquad on my 79 road runner. I had similar issues. Bad accelerator pump. Rebuilt the carb, and the hard hot start issue was caused by a bad thermostatic choke control. It still had some ‘spring’ to it, but not like a new one. If you can’t find one for the...
  4. Love Shack

    Changing stem seals / adding valve springs with the heads on

    I’ve done that with the heads on a couple times. I think in the factory shop manual on this. Use caution. I always oil the new seals before I put them on. As stated above, be sure the locks/keepers are correctly seated before moving on to the next one. Good luck.
  5. Love Shack

    Choke spring replacement

    I don’t know if there are differences in tension when new, or if the main assembly is the same, and just different choke rods?
  6. Love Shack

    Choke spring replacement

    I needed one for a ‘79 Thermoquad, with heat assist, which was not available. My parts pal at Bumper to Bumper, found one for a 2bbl, which looked identical. All I had to do was swap out the choke rod. The car always started hard, lots of cranking. The old spring still had tension, but no where...
  7. Love Shack

    Muffler suggestions

    Mufflers? We don't need no steenking mufflers!