Separate names with a comma.
Even though i now run the holley pump, i still have the stock 5/16 line and adapt it down at the pump. The car runs 12.28@110 with that setup.
I fill the pump cavity full of Lubriplate 105 assembly grease, works like a charm. Napa always has it. No. 105 | Lubriplate Lubricants Co.
I use this base Keyser Manufacturing Aluminum Air Cleaner Bases 100 68826 It works with either a k&N filter and lid, or the stock top and stock...
I run this holley pump part#12-440-11. it is internally regulated at 6.5 psi and 110gpm. I put it on because the pump on my car was the original...
My 66 newyorker 505/512 has the stock 5/16 line and a holley mechanical pump. I run 12.20@110 mph with that setup.
Performer RPM and a Quickfuel ss830 carb with mechanical secondaries and an electric choke. Runs like a champ in town, and runs like an animal at...
Or swap out to the 2nd generation green bearings. Either way is perfectly acceptable.
I am running 3.23's
Faster than that now. 12.30's@ 110[ATTACH]
These guys built my 2800 stall. With modern cam grinds, the old "big cams have no bottom end" is greatly minimized. My car is an absolute hand...
That is how the rod looked when i rebuilt the original motor, it ran perfect and never made a peep, and had great compression prior to the rebuild...
The trick to take it out of park work like a champ, however the car will not shift out of 1st now. I am calling A&A tomorrow.
SWEET! This board is something else!!! [ATTACH]
Great! This board is something else...... [ATTACH]
I installed a A&A 6200 RPM governor in my 727 in the car and am having a bear of a time getting the parking rod back in correctly. Anyone have a...
Just put a hydraulic roller in it. After many flat tappet failures in small and big block chevys, i dont think i can ever use a flat tappet...
If you are going with an off the shelf grind that will be fine. The guy who ground my cam used my actual flow numbers when he ground the cam. I...
For a short time i ran a stock aircleaner, unported stock stealth heads and the stock log manifolds.....the car ran 12.80's in that configuration....
I am running a hydraulic roller from straub technology. Chris is a great guy and his cam is spot on for my stroker. I have posted the specs here...
The guy at A1 wanted all of my info as well car weight, engine size, gear, cam specs and built my converter based on those numbers. I told him i...
