Search results for query: *

Go to this website The Electrical Depot. They keep in stock Packard 440 wire terminals both male and female for most of our Mopar needs they also stock common electrical plastic connectors commonly used on C bodies. For bulkhead connections and connectors you will probably have to use eBay as a...

Devinism is by far the way to go. I have used him in the past and his quality is by far the best of any Rebuilder and of the same quality like purchasing new.

,@Devinism is who I use for pwr window switches as well for light and dimmer switches. Excellent turn around time.

Your seconf picture is what I used as a replacement they're available for super bright lights and are very reasonable and price

Go to Harbour Freight and buy the 5 pcs trim removal tool set. Cheap, but very effective. Don't use a screwdriver it will dent your trim.

Remove the stainless trim from the fender w/ the screw removed in the following steps. First apply masking tape to the fender on both sides of the trim to avoid scratching the paint. Next w/ your trim removal tool carefully pop the trim off the fender starting at the rear and moving forward...

Check the main driver's door wiring harness if the circuit checks out to be good. A common failure point given the symptoms mentioned in you post. Broken 12-volt supply and ground wires are pretty common well worth checking into.

I agree it's a very hard switch to find. You might contact devilizm here on FCBO and see he has one.

These are sold by Dodge Boy on E-Bay. I have them on my 69 300.

If you have replaced your flasher check your grounds at the sockets in the rear and the ground wires at the front turn signal assemblies. Next check all your connections for corrosion, don't forget your firewall connection as its problematic.

Removing the ignition lock cyl wil give you more leverage.

Type in the info as in the my post in the E-Bay search. Light housings vendor name is Starklights , upgraded 6000K vendor is 6sports. View attachment 407230

No. You look up under the dash pad you should see light bezel. Drop the steering column down for ease of removal. Remove all the screws and position, the vent and map light assemblies out of the way. Carefully and gently pull down the upper bezel and disconnect the instrument light connection...

It's just the 2 bulbs.

Here is a pic of the results of the above post 10.

I have a 69 300 and this is what I did. Remove your upper dash fascia. Your dash fascia is illuminated w/ 2 bulbs. To get maximum performance drill out the rivets that hold the dash lite housing. Next remove the lenses. Spray paint the reflective inside w/ bright silver paint. Next replace the...

Yes it is made by OTC.

You will need a real puller to take it off.

You will need to pull the dash cluster as a unit. The switches are install from behind the cluster. Don't do w/ the cluster installed, its too easy to break something there is no room in there. Disconnect the battery. Remove the lower steering column cover and drop the column down for easier...

Here is the scoop on the headlight conversion. The Headlights are made by Stark Lights. The bulbs that came w/ them were inadequate so I upgraded to H4 9003 Led bulbs Rated at 2400 watts. Some mods had to be made to install. Overall costs weren't bad under 55.00 dollars. Ampere draw was...