Separate names with a comma.
hey all thanks for the replies. as 413 mentioned, the 65 and 66 consoles are quite different - both pretty fricken cool in their own right, but...
Hi All I have a 1965 Dodge Monaco - stock drivetrain was 383/727 I am replacing the engine with a 440 (stroked to a 522) expecting roughly...
its an original Holley that has been reworked - Ive always run Carters and then Edelbrocks but I do have buddies that have great success with...
FYI - while it could be modified to work - the two brackets are different. Since Ill likely go back to an Edelbrock at some point Im not going to...
mechanical fuel pump - don't have a pressure gauge in line, but tested when installed and was 3.5-5 lbs. Thanks for the tip on gasket - I...
1407 - manual choke - not hooked up. plan to run a 650 vacuum secondary - no choke long story is i bought the 1407 and installed it with a weiand...
well dat'd be convenient....for once! haha thanks Commando!
Guys, Its a rather long story but Im wanting to swap carbs for a few reasons this evening after work - I have a 650 Holley that's been previously...
im interested in the diagram Eyemon - thanks. Ill also check out your pump as I haven't picked one yet - how is noise on the unit you have?
totally misdiagnosed this one - ruled the cable out by removing the gear - test run, squeak still there. Went to rear ujoint - it wasnt good but...
yea, I pulled the gear last night - somehow ive got the later model cable and gear [IMG] but it looked fine - ill check u joints next
so ive just found out that i have the same style cable and gear you have pictured in red (except mine is a green gear) Ive got a 65 monaco and...
yerp - I get that - ive no clue what the PO did - assumed nothing - Im hoping it is just the cable but Im thinking it may have compromised the...
I have a fuel filter with viewable site glass before fuel pump and between pump and carb. When I turn over the engine, gas will begin to fill up...
thanks - will be doing and report if next steps needed
thanks John - that helps - wasn't sure if I could remove the cable without tranny draining. It doesn't sound like a u joint or rear bearing whine...
Ive got another one for you guys today My speedo needle was jumping all around when first got the car a few months back and cable sounded like it...
bringing this thread back as its nearest to my issue and question that I can find in the search function I have been chasing a fuel starvation...
