Separate names with a comma.
Morel roller lifters out, Johnson lifters going in. I have had a few occasions where the Morels have failed to maintain pump-up, and suffered an...
I have a rear window motor that will not go up either with the master drivers door switch, or its own switch, I have the assembly out of the car...
Not specifically mopar related, but its cold outside and the posts on here are a little slow lately. My new project build. Just fired up my...
My chevy twin to my 505/512. My mopar build was a blast so i decided to build a big block chevy for one of my trucks![ATTACH]
I installed a A&A 6200 RPM governor in my 727 in the car and am having a bear of a time getting the parking rod back in correctly. Anyone have a...
[MEDIA]
Driven to the track ~70 miles 3.23 gears with detroit locker 4767 lbs The popping and banging you hear is the ricer in the right lane. [MEDIA]
Any quickfuel carb Jetting guru's on here? I finally got around to installing an 02 sensor in my 505/512 stroker and got some readings at various...
Got the new Mickey Thompson ET street R tires 275/50 15's mounted. They fit under the fender skirts. Should get me to 11.99. If you look close...
This year I have made a few changes to hopefully get into the 11's First off i purchased and installed an innovative motorsports 02 sensor so i...
[ATTACH] [ATTACH] I swear, I will run 11.99 this spring"
Anyone running nitrous on their stroker? I think i am going to add a 150 shot to my 505/512 stroker. Can you run the nitrous outlet stinger wet...
I need a 489 centersection for an 8 3/4. Preferably in washington, oregon, or idaho so i can pick it up. Gear ratio does not matter.
I recently removed and repaired my gas gauge in my 66 new yorker. The gauge cluster removal required loosening and dropping down the steering...
After my comp cams hydraulic lifter failure on the way to a car show last summer, I replaced my cam and lifters with a straub technologies custom...
Anyone running a custom straub technologies cam?
Comp cams hydraulic roller tie bar let go while cruising down the highway at 55 mph. I let off the gas and heard a little ticking. The tie bar...
Sent my heads in to have them CNC'd. They look beautiful. Flow numbers were a big improvement over unported. While the motor was out, I...
My car was originally a power drum brake car. I converted to a dual circuit master cylinder with the drums all around for saftey. Later I...
