Separate names with a comma.
In 70 they used the same hose for top and bottom, it was the same as the lower hose in earlier years. This will work for you. Alan
These are pictures from a setup that Matt sold in May, at first I thought it was yours till I saw the fittings, the upper hose has a straight...
Thanks, Do you recall what year this was from? The lengths are the same as what I had on the car, the new hoses are 16" longer (each side) not...
The pump is high, One hose mounts to the rear of the pump and goes to the bottom of the cylinders One hose mounts to the front of the pump and...
If they appear to be original that would be great, also if the ends are all 90s or straight, or mixed. Thanks, Alan
I needed to replace the top lift cylinders on my car and chose to replace the hose while I was in there. The hoses on the car were about 80"...
Just checked, no holes. Console is black (should be blue) so it isn't the original, it is an original console car. Alan
It is a 69 Polara 500, I'll check for evidence of the clips, I haven't had much time to look at the car in the last couple weeks, hasn't been out...
My 69 Polara is an original console car, no cigar lighter, no belt clips. Alan
I know this is an old thread but it didn't address the later consoles that appear to be different. The parts book isn't clear in trying to...
There is no excuse for taking over 6 months to do door panels, the process doesn't take that long. Wit that volume of work stacked up is more than...
I'd also suspect the guide pins on the front of the glass, not the pins exactly but the seal that goes with them. Alan
4-door rear seat base has a different shape. Alan
Door Sag, Alan
I was transporting a car from Los Angeles to Grants Pass Oregon, loaded my seats and dropped them off on the way by along with the material from...
Valley Vinyl 2937 Merriman Rd, Medford, OR 97501 (541) 842-4773 They know what you need, been there done that (four times now) Tell them Ron and...
I needed some vinyl for my b-pillars and gave them the interior code and a description, top sample was the correct one. They may need a sample or...
Put spacers under the front mounting bolts. Alan
The ball-joint is attached to the vent shaft. The vent shaft has a couple nubs on it that hold tiny blocks (2) with a hole in it, the blocks are...
It is possible that the ball-joint came apart, it is crimped together. There is also a chance it is an internal issue. Alan
