Separate names with a comma.
Here is a 1969 picture of a 1969 CHP Polara, [ATTACH] and a picture of a somewhat original 68 CHP Polara taken a few years ago. [ATTACH] Alan
Yup Alan
All Black, I have a period picture (1969) showing this I can get in a couple hours. [ATTACH] Alan
I had a great mechanic in Grover Beach that only worked on vintage stuff, particularly Mopar, he moved to Idaho I'm not much of a mechanic, looks...
Are you sure that it has disc brakes up front? that is a drum/drum master cylinder. Where about is SB County are you? North county? Alan
This is my 69, a little different. [ATTACH] My interpretation... [ATTACH] The key takeaway is the three points of contact for the tire so it...
Lug nut torque specs are in the factory service manual. Alan
The difference is where the boot goes around the frame, you could carefully trim that part and use it, otherwise they are the same. Alan
Disc... [ATTACH] Drum... [ATTACH] Alan
Here is one on eBay Mopar Dual Master Cylinder, Brake Line Distribution Tee Block | eBay The bracket is the only thing that makes the ABE ones...
If you are doing other work like ball joints put the shock in first (top). Alan
This is a relatively common part, your local AutoZone should be able to get one. RockAuto, O'Reilly, etc. Alan
I had the same issue, replaced the bearings, problem continued, replaced the axle housing, problem solved. The housing was worn where the bearings...
On the broadcast sheet Line 4, box WH/COV code 24 is for part number 2881824, the illustration in the parts book shows that as the ones on the...
I took a minute and looked into the smaller pin. The factory parts book shows: 19-15-23 BODY 2766202 (1966) no mention of the pin 19-15-23 BODY...
Again, not all factory housings have the smaller pin, I cannot define the perimeters for those with or without but both do exist. Alan
Since I was working on a bare shaft I wasn't thinking about the orientation of the housing on the shaft. The notch on the housing goes up, if your...
No Joy, these housings are clean, I took this one apart to examine in detail, my Barracuda is the original and it was quite clean when it was...
Make sure to check the tabs as you go as to not pinch them. [ATTACH] Once you have done one side the clamp isn't needed, [ATTACH] Wipe it off...
The seal stretches enough to put it on over the pin on the shaft. [ATTACH] For the purpose of the demonstration I used lithium grease as that is...
