Search results for query: *

Hey I'm looking for a 1964 Imperial A/c radiator. I'm also open to a 1962, 1963, or 1965. Thank you in advance!

Hey I'm looking for carter high step jets that work with the 3 step rods. I want to keep some spares around and also create a "strip kit". I'm looking for high step jet sizes .089, .098, .0101 and rods 16-160, 16-173. Thank you in advance!

Hey I have a 1964 Imperial and I just re ordered Raybestos BC92270 for the rear parking brake. The original one I installed I must have nicked the cable sheath and spring and it started to stick inside the housing. I thought I better get a new one in case it starts to cause a problem. Well I...

Hey I was wondering if imperial rear backing plates are the same from 1963 to 1966? I know the drums are different with the different axle styles, but the interchange manual I have lists the shoes as the same. The book just doesn't list anything about backing plates. Thank you in advance!

Hey I'm looking for carter 3 step rods for my 64 Imperial. 16-160 (.0645 x .063 x .055) 16-173 (.0655 x .064 x .061) 16-216 (.0625 x .058 x .047) let me know if you have any, thank you!

Hey I was removing my carburetor from my 64 and the one end of the throttle clip just broke off! Is there any way to repair it or do I need a whole new cable? Thank you in advance!

Hey I'm adding auto pilot to my 64 imperial, and I think I'm missing some of the linkage. I'm also not sure how the linkage should be setup and I can't find a great diagram that shows exactly where everything goes and goes through. Does anyone have any photos of the linkage and how it is set...

Hey I own a 1964 Imperial that came with heat only and I'm converting it over to an ac car. What's the difference between Imperial crankshaft pulleys throughout the years? Does the harmonic balancer also have a specific ac type over the heat only ones? I was looking into redoing my harmonic...

Hey I have a 1964 Imperial and I'm trying to find other options of rims that would be similar enough to my OEM set, but could accommodate a rotor better. I still want to retain the 5x5.5 bolt pattern and 15inch rim so i can still use my hub caps. I thought about 1976 to 1986 Jeep Cj5 rims but...

Hey I was wondering if anyone has a 1964 Imperial automatic headlight dimmer schematic? I'm looking for one just in case I need to replace anything in the future. I'll include photos of what was pasted inside the case. Thank you!

Hey is there any way to replace a shock mount bolt on imperial shock mount plates? The threads on the end of the bolt have been damaged and the end looks like it was hammered in and mashed to one side. I was wondering if you can simply replace the bolts or should I try to look for a new...

Well I just found out that my 1964 imperial actually has a 1965 drive shaft! I don't know if the original owner placed it on the car or If it was from factory (my car was produced in June of 1964) I'm about to replace all of its parts,u joints, ect. but does anyone have any part numbers or...

Hey I just pulled my drive shaft off of my 64 Imperial. The center carrier bearing is shot and the rubber housing needs replaced. The housing definitely had something wrong because It was easy to pick up the drive shaft and move it all over the place! I wrote damper dr, but does anyone have...

Hey I was changing the transmission fluid when I noticed a crack starting in the transfer plate right by the filter and going to the complete edge of the plate. The car shifts fine and I haven't noticed anything odd from the transmission but the crack was pretty alarming. Does anyone have any...

I ordered an ac condenser last winter so I could build my ac system this summer, but when I went to just mock fit it in my Imperial it's way wider than the radiator hole! Should I search for a new one? I can't return this one unfortunately, but I'm worried that airflow around it could be a...

Hey I'm putting back in the dual ac system in my car. When I bought it, it had all of the ac lines missing and some of the ac parts too. I need an idea of how the lines would have gone to the back of the car. Did it go through the cabin? Or run by the frame? It's been a very confusing journey...

Hey everyone I've been reading alot of threads that talk about converting their transmissions to 518. Has anyone ever done it on a 1964 Imperial? Also what kits are out there so I can still use my push buttons? Some of the threads are too old and the links go nowhere! Thank you in advance!

Hey I've been toying with the idea of figuring out a way to add abs to my 64. I've had a couple close calls with the brakes locking up and I'm wondering if it's even possible. I know the later 60s and early 70s Imperials had a form of abs, but I bet it's pretty rare or not as effective anymore...

Hey I'm looking to replace as many rubber bushings as I can on my car. I'm adding new leaf springs so I have the bushings for it. But I'm looking for the rear strut bushings, sway bar bushings and any other bushing that you have listing for. Thank you in advance

Hey I'm looking for a new ac blower motor. Some websites list it as needs to be specified with ac or no ac and others don't. Is the heater blower the same as an ac blower but with the addition of a resistor for the ac? Let me know! Thank you!