Search results for query: *

  • Users: Catfish-65
  • Content: Threads
  • Order by date
  1. Catfish-65

    Is it time to replace my Oil Pump

    Hello all, I have a question regarding my oil pump. When I first start my car (65 Polara with a 361ci auto) cold the oil pressure on the gauge is right at 40#s. After it warms up to180 degrees at an idle it drops to about 20#s, when I put it in gear it drops to about 12#Oil is clean and the car...
  2. Catfish-65

    Aftermarket Amp Gauge wiring question?

    I am installing an after market Amp gauge in my 65 Polara. On the back of the gauge there are 2 post left has (G) stamped beside it and right post has an (I) stamped beside it. Dose this indicate G to ground and I to hot wire when ignition is turned on. Also can I just leave the dash idiot lite...
  3. Catfish-65

    bucket seats and floor concill for 1965 dodge custom

    Just checking to see what a pair of bucket and center councel complete would be worth 1965 one year only cable shift,,, Thanks
  4. Catfish-65

    Oil Gauge Question.

    On my 65 Polara 383 I have an idiot light on the dash, that comes from back of block drivers side. A few inches toward the passenger side roughly same location on block is an Allen plug, Can I remove the plug and use a proper oil gauge and line to mount inside below the dash, My guess is yes so...
  5. Catfish-65

    Seal beam headlites.

    This may seem like an odd question but, If I put a hot wire to one prong and a ground wire to the other prong on a seal beem it should turn on , If I,m in error please set me straight.I,m getting power at the head lights but no lights. on all 4 lights,, Scratching my head for sure,, Help...
  6. Catfish-65

    Headlight Switch.

    Having some issue with headlights not working and wanted to remove te headlight switch so I can check it out and replace if need be. Problem is not sure how to remove the dash nob without breaking something. Is it screwed on or pressed on not sure. I could use some input. It is on my 1965 Dodge...
  7. Catfish-65

    1965 727 Trans kickdown cable

    When the gas peddle is push down should the trans linkage begin to travel back at the same time or should there be a delay before it starts to move, when I kick it down when driving it does not seem to go far enough to engage the passing gear, info would be great,, Dave (Catfish65)
  8. Catfish-65

    Medicine Hat Alberta Members

    Just checking to see if any members live in the Medicine Hat area of Alberta. Looking at a move to that city.. Catfish-65
  9. Catfish-65

    Oil flow Question.

    With the valve cover removed and the engine revving approximately 1K.. should the oil flying around or just be a slower drip and flow around the rockers, it does not throw oil out toward the inner fender. Checking to see what would be considered normal,,, Dave (Catfish-65)
  10. Catfish-65

    Power Steering Issue,,

    Hooked up the power steering pump on my recent engine install 383. pump is on engine, after installing I filled with new fluid to bottom of neck (cold) I have the engine running now up off the ground and when running, the pump make the wheels travel to the left side on its ownI can return to...
  11. Catfish-65

    Distributor Replacement Question

    Looking to see if anyone has had experience with Proform 66993 Electronic Conversion Distributor kit,, For 361, 383, 400, etc change from original equipment,, Catfish 65 (Dave)
  12. Catfish-65

    Engine won,t Crank over at key,,,

    Went to start my 65 Polara and had nothing at the key.. Have lots of battery and it will crank over and start when the terminals on the starter ar crossed,, Where would a good place to search for the problem start, Not real familiar with the starting system for Mopars, Appreciate any help...
  13. Catfish-65

    Intake insulation pad,,,

    Anyone know where I can find an isulation pad that goes between the intake and the tappet windage tray on a 383 ???? Catfish65
  14. Catfish-65

    Spring shackle Alignment Question

    I,m having the springs on my 65 Polara re-arched and would like an opinion on locating rear shackles, should they when under load just ahead of the shackle perch center, right below center or just behind center. this answer will help to achieve the center to center measurement on the bushing...
  15. Catfish-65

    Timing Chain back lash,,,

    How much backlash should there be on a timing chain and sprocket,65 BB mine seems like a fair bit when moved with a bar and socket,,just wondering if it is time for a replacement,,, Dave
  16. Catfish-65

    2 four Barrel Intakes..

    Looking at 2 intakes.. 1/ date code 6 26 69 #2951736 2/ Casting # 3830733 Both are 4 barrel intakes,, will they both fit on a mid 60s 383 and what would be considered a fair purchase price I,m looking at buying both,,, Dave (Catfish) Pic to Follow
  17. Catfish-65

    Bleeding a Dual Master System

    Question is, are the front and back of the cylinder totally independent of each other and does it matter which is bled first below the bowl,, Catfish,, (Dave)
  18. Catfish-65

    Removing oil pump on 361 -383

    I have removed all bolts from the pump and removed the filter it turns around freely but will not pull out of block. Am I missing a step.. THX
  19. Catfish-65

    C Body Deaddock

    Just dumped every think to do with C Body Dry Dock.. Too much weird language posts and less fun than spending an evening listening to an ex Wife.. No time for either,,, Thanks for this Site is conveyed,,,,Dave Catfish65......
Back
Top