Search results for query: *

selling my Quick Fuel 735 VS. It’s practically brand new but I found it a little too big for my application. I’d like to get $375 shipped for it. I’ll snap a few pics but all the info is in the link below. Quick Fuel HR-735-VS HR-Series Carburetor 735CFM VS

Does anyone know if a reproduction is made? DMT doesn’t seem to carry them, only for the Monaco. Mine are toast of course. I don’t really drive in the rain but....I’d like to know they seal.

sold

Been looking around for one. If anyone has one they’d like to part with I’ll take it off their hands.

Selling my Holley intake manifold. It’s clean and in good shape. The previous owner made an attempt to smooth down the “Holley Steet Dominator” that was on it. Not sure why but it doesn’t look too bad. I’m looking to get $100 + shipping ball park. Here’s one on eBay for a comparison. Mopar 383 /...

Well I'm taking a shot here. If anyone here is in the PNW and could recommend a transmission shop I'd be super happy. I'm pulling the engine and trans next week and would like to freshen up my 727. Thanks in advance.

just wondering if anyone had a set hanging around that they'd be willing to part with. I'm getting around to a suspension refresh.

Ok guys looking for some help. I Had to remove and reinstall the passenger side head. Long story of cursing and yelling about a snapped exhaust manifold stud. i cranked her up to bleed and burp the coolant and I'm getting some valve train noise. I used my trusty mechanic stethoscope and it's...

gently used for about 150ish miles. Works great but is not compatible with my Sniper EFI I'm installing. $130 shipped obo. PayPal accepted

For sale is a barely used pertronix ignitor 3 module for BB Chrysler distributors. I put roughly 150 miles on it and it works great. I just can't use it with my sniper efi setup as it's multi spark and will not provide a clean tach signal for me to use. Summit sells them for $149. I'd like to...

I bit the bullet today and picked up the Fitech EFI 600 HP kit from Pace Performance. Got the fuel command center to go with it for ease of installation and also a new distributor as I'm going to control timing with it as well. Super excited, followed a huge thread on FABO on them. I'll post up...

Found this down the road from my house. Looks to be in decent shape. Classy 1966 Chrysler 300

Well as the title states I'm playing games with my 66 300 383 4bbl. I finally got around to replacing the coil, cap, rotor, points and condenser as part of my just purchased maintenance. Of course she won't start now. Triple checked the plug wires on the cap and the firing order. Even put old...

pictures worth a thousand words. How do I get the lever out? I have to replace a spring in the low/reverse servo with my TF1 shift kit.

Hey guys, I'm going to check out a 66 300 hard top 2 door. Any advice on problem areas to check out. I already know it's got a small bit of rust behind the drivers side rear wheel but it looks clean otherwise. It's got buckets and a console and is supposedly running and driving decent. Like I...