Search results for query: *

I have not, but will now, based on your suggestion. Thanks!

A very good idea, but I no longer have the old condenser.

Yes, the car ran fine before the repairs. Reason for the repairs is that I wanted to detail the engine bay, which is now completed. As a result, I have a great looking engine bay in a car that backfires!!! My Dad always said, "leave well enough alone".

Firing order ok. On idle, no miss, runs smoothly.

1963 Imperial 413 engine with 25,546 original miles. I replaced the points, rotor, cap, condenser, plugs, ignition wires, installed a carburetor kit, installed a new intake manifold, new water pump and timed the engine. The Y pipe is on the exhaust but the muffler and tail pipe are gone and...

I did not change the fuel pump. Thanks for the suggestion.

Mine did and I thought I measured it correctly, but it is overloading.

I cleaned and installed a new kit in the Carter AFB 4 barrel carburetor off of my 1963 Imperial 413 engine. I adjusted the float according to the specifications but I must have it too high, as it is overloading with fuel. What is the correct float level and drop level and what do others use as...

I installed a new intake manifold. Is there a way to check for any vacuum leaks around the edges of the intake manifold?

I cleaned the AFB carb and installed a new kit. Car starts fine, idles ok for a little while, but then it seems to "load up" and then will die, unless I increase the RPM. Do I have the float set too high? I followed the owner's manual as to the float measurement. Thanks!

I found some on Summit. Which size would I need for my 413 engine, .375, 5/8, or 1 inch diameter?

Where did you purchase the sheathing insulation for the fuel line? Did you cover from the filter to the carb?

1963 413 Engine on Imperial: I have the intake manifold removed from engine. Before installing I some questions. There is a lot of information about blocking off the exhaust cross over to help prevent vapor lock. Fel-Pro 1215 is a metal pan gasket with the ports blocked, but you have to add...