Search results for query: *

Sorry. 68 Dart BB.

Since I've been gone I finished the PS upgrade. Works Great with a little floating Issue , probably a caster camber thing. On the maiden voyage , I let the car idle for about 20 min to watch temp as I was having heating problems. After 20 min it was heading for 200 D . I took it out and by the...

Looks like someone's trying to milk the Chevy.

When I had My 354 in it I would get stuck in close quarters and muscle my way out. There was no way I could put PS with the old Hemi. This was a last minute decision , the cost was minimal and it was actually easier then putting my speedometer cable in.

Ok pictures as promised . Theres so much going on in a little space its hard to see. You Cbody guys are lucky. A lot to stuff in a small area.

Little up date its been awhile been busy. Some of you know I was putting power steering in the Dart. I was having a hard time finding the right pulley . Ended paying way to much on a new repop but it works . The system is tight but functions well . Going to take it for a run tomarrow. I'll get...

No 11/16 is a true measurement . a friend of mine was going to give me one but it measured out at 11/16 all so Mopar did some weird stuff.

My thoughts too.

I bought a pulley from someone . He thought it was 5/8 x 5". I got it and discovered that it slips over my 5/8 " steering pump shaft (federal). I measured and it looked like 5/8 but when I put the calipers on it , it was actually 11/16. I've never heard of a mopar shaft of 11/16. can I sleeve...

I'm assuming A body and Cbody power steering are the same. Anyone know the size of the input shaft to steering coupler. Zigs

Got my steering pump today . I was surprised . it actually looks pretty good. All the stories about Cordone products and of course they had to dip it in a five gallon bucket of 10W30 before they sent it. I measured the shaft and it is 5/8" and I believe the correct pulley is 4 3/4" So what I'm...

I just noticed your avatar I also was in the Navy 68-72

Thanks Mike , I've seen the 5' also that's where I'm getting confused. I've been told they used both

I'm looking at aP/S pulley a guy has. It shows to be 5/8 shaft hole and 7" diameter. My pumps is for a 68 dart 383 Federal pump press on . He's not sure what year pulley. Does anyone know the correct pulley for the 62- 68 Federal BB pump?

Thanks that's I wanted to hear

Is the power steering line anything special can a fuel line be used its not under pressure. I have a section of fuel line. Most pictures show it being held on with hose clamps.

Ya I did that on purpose got so much flack from ABody guys I put it back.

1968 Dart 2DRHT 400/471 stroker 727 489 sure grip . Also a matched set