Search results for query: *

Thanks for the link Tim. Universal hangers don't fit well w/ our 69-73 Chrysler models. The exhaust from Waldrons fit pretty well. Universal hangers were found everywhere w/ this hacked exhaust system I removed. There are some very tight clearances over the rear axle and rear bumper. Just trying...

hey 413, my car is a C body ,i didnt see 1972 C body on that link thanks

There are 2 types of pulleys. Some will be needed to just pulled of others are with a nut. Here is mine, without nut. Just pulling it of with force and a special tool. Like this

Yes, but is there a nut that requires removal before I press the pulley off?

World's Largest Mack Truck Is Getting a New Shot at Life After 55 Years The frane alone weighs over 95,000 lbs. One of three that were made.

No man, they don't make them! Aren't you listening??? I love it when someone tells you something that you know isn't true, but they insist you're wrong. Good find 413 and 67_300.

I cleaned it up again and this time filed the contact areas, like MGM86. Now it's working fine. Thx all! Here's some dirty pictures

No. No pulley included, you need to pull of the pulley with an extra tool. Needs much force. It's pressed on. I bought this one. BGS technic Riemenscheiben-Abzieher & Montage-Satz | für GM, Ford | 13-tlg. 4026947077543 | eBay I needed about 20-30min to took of the pulley and press it on to...

I rebuilt my dimmer switch for the same reason and it has been working well although I only have a hundred or so miles on the car with the lights on. I cleaned all of the terminals, the spring inside, and the little metal clip on the arm that runs along the spring. I used Gorilla glue to put...

I recently rebuilt my non-AC heater box and it wasn't too bad of a project. I would check for cracks around where the vac. actuators are riveted to the box. I repaired the cracks with fiberglass epoxy resin. Definitely recommend the gasket set from detroit muscle as posted by @3C's & a D? I...

Anyone Have A Use For These Bolts before I deep six them? Free, just pay shipping.

Show Rob this page Menu_340_Headers

I answer to myself. I used SoffSeal E202. Slightly smaller than the original but still 80% bolt on job. There was up to 3/16" height difference between different batches of the seal. Glass adjustment had to be done.

regarding tti, robs rod shop insisted that tti do not make headers for the 360 / its a 1972 plymouth fury 360 engine and 727 trans /check out hemi or not to hemi thread for the pics thanks

Most of the places selling NOS items typically ask big money for parts they sell. Thought you mentioned you were looking for an NOS hanger. Thats why I was trying to help you out with the link. Since you already bought up everything, send a set to @david hill to install on your car.