pulley and pump question

zigs

Member
Joined
Mar 26, 2017
Messages
106
Reaction score
26
Location
Yakima washington
I bought a pulley from someone . He thought it was 5/8 x 5". I got it and discovered that it slips over my 5/8 " steering pump shaft (federal). I measured and it looked like 5/8 but when I put the calipers on it , it was actually 11/16. I've never heard of a mopar shaft of 11/16.
can I sleeve this? Can someone use this ?
 
I bought a pulley from someone . He thought it was 5/8 x 5". I got it and discovered that it slips over my 5/8 " steering pump shaft (federal). I measured and it looked like 5/8 but when I put the calipers on it , it was actually 11/16. I've never heard of a mopar shaft of 11/16.
can I sleeve this? Can someone use this ?

Probably the previous owner bored it out in hopes of fitting it on a Saginaw. If so he couldn't even do that right as press on ones are about .002 smaller in bore than the shaft not 1/16.
 
No 11/16 is a true measurement . a friend of mine was going to give me one but it measured out at 11/16 all so Mopar did some weird stuff.
 
Back
Top