Water transfer

[ALL_I_CAN_C]

http://youtu.be/pKuXyeAGzEU


Kinda cool. Anyone out there went this route on any of their c body parts?

 

[53ryder]

That is very cool! Will never look a decal sheet from a plastic model kit the same again! Neat how the holes or slots don't have to be trimmed open. It looks a few twists or shakes must break the excess decal off whatever is being dipped. Again very cool! Wonder how much?


Glenn

 

[53ryder]

OOPS! Nevermind!

 

[commando1]

I can see a huge business in refinishing "woodgrain" dashes but unfortunately I'm pretty sure all you'll see come out of this is carbon fiber dipped Civics and gaudy Donk wheels.
The flame job is unbelievable.

 

[ALL_I_CAN_C]

I was thinking the same thing about the wood grain, but on the outside as well. Looks like it could be done on front fenders and doors but the rear quarter is another story. Would pretty much be limited to steering wheels/columns, dash pieces, interior panels, and wheels. The cost isn't out of this world either

 

[Stormer]

Wow, that's amazing.