66FURY_III's latest activity
-
No. I spent hours rummaging through a junk yard trying to find something close to what I could use. I can't remember what each one came... -
Commando 1--- Did you use the Schumaker A body to BB mounts? As I mentioned I have a set I was thinking at one time of using in a C body...
-
I have done a /6 to a BB swap in a 66 Fury. Personally, I wouldn't do it again. I should have have used the Schumacher A body /6 to SB...
-
66FURY_III replied to the thread Engine Swapping the Slant 6.Great advice Travis, thank you!
-
No idea where you could find the parts. Out west here, frames survive quite well. But they have mostly gone to the crusher too. Good...
-
66FURY_III replied to the thread Engine Swapping the Slant 6.I think that I'll have to go out and cut those mounts off and try my hand at welding them in. I've put another email out National...
-
Since I was asked, here goes. I suspect the location of the frame mounts would be the same in any of the body styles. But, I don't know...
-
66FURY_III replied to the thread Engine Swapping the Slant 6.Thanks for those tips! I think I'll elect to plug those ports for the smog nonsense. I didn't find any extra smog pipes when I took...
-
85 will have the A998 lockup trans with the super low first gear since most M bodies had a 2.2 rear gear ratio. Not a bad transmission...
-
66FURY_III replied to the thread Engine Swapping the Slant 6.Thank you for clearing that up Travis, I guess I will have to see what is involved in fabbing up those perches. I imagine I could get it...
-
66FURY_III you posted above (last April) that you were in touch with National Moparts about getting a sub-frame. How did that work out...
-
66FURY_III replied to the thread Engine Swapping the Slant 6.I did call National Moparts a few times last year however they did not have any in stock. I am still on their call list if they do end...
-
Why is this a "slant-6 to big block" conversion mount (and not a slant-6 to any V-8), and Why is it only for A-bodies (why would the...
-
66FURY_III replied to the thread Engine Swapping the Slant 6.I just wanted to give an update on this project. I have purchased a 318 with a 904 from a 1985 Fifth Ave, this car was driven to the...
-
It's got an eight cylinder engine, how about we get it working on all eight? Better. Cleaned the plugs. Really needs new plugs but that...
