67 ragtop's latest activity
-
Something like this, while it might not be your problem, isn't good on any level. That's the very first thing I would fix... and if it... -
67 ragtop replied to the thread The wanderer.I just saw this on a You tube video from Uncle Tony's garage. As I was looking closer at the steering system I saw that the pressure...
-
One thing that's often neglected, because it involves more disassembly, is the lower control arm bushings. That's one of a lot of...
-
67 ragtop replied to the thread The wanderer.I have Cooper P225/70R14. I replaced the Ball joints , front and rear Shocks, Idler arm, tie rods ends, and front wheel bearings. I...
-
You might increase the caster to the max possible and still have camber in spec. Seems like the power steering caster spec is +.75...
-
I think it may be normal but my 67 Sport Fury needs constant feedback when driving AT 65MPH. I can let go of the steering wheel and...
-
67 ragtop replied to the thread low vacuum 383.Thanks I replaced all the plugs. just because. I wiil clean the old ones and save for later, I still have a spark plug cleaner from the...
-
You can "drive the plugs" clean, get new ones, or knock the soot off of the ones you have. DO run a gap gauge through them to clean the...
-
67 ragtop replied to the thread low vacuum 383.I found 2 problems. The carb was flooding out the float was set wrong. Also I was wrong about the compression. the specks I gave were...
-
-
Distributor specs are om the "Ignition" section. Idle speeds are usually in the "Fuel-Carburetor" section. CAP cars probably were...
-
67 ragtop replied to the thread low vacuum 383.So far I have only driven it with 10 degrees initial and no pinging . It was also cold that day/ All I can get around here without...
-
Looking at 1967 Polara / Monaco service manual. BBD 2-BBL, 383 engine. Curb idle (with A/C on) is 550 regardless of transmission. For...
-
Cardone make a good product that may be great or a dog in your application. They usually have a ten year spread of "it will work"...
-
Good luck getting a B/RB points vac advance now from a parts store today. They will give you one with the curved arm not a straight arm...
-
67 ragtop replied to the thread low vacuum 383.Thanks I appreciate it. I called Mancini racing and that one won't work on a single point distributer. it is for electronic ignition...
