Hey guys,
It has been a while, hope you are all doing well! Now that I am in college, I don't have a ton of time for the NYB, but I have been helping a neighbor who fought in Vietnam as he tries to sell his 1975 Chrysler Cordoba during my breaks. I had a few questions:
1- I will post pictures...
My dad and I went last year and thought it was really cool, just wondering, do they change the exhibit year to year. I think last time it was truck themed
My dad and I will be there again this year in the big New Yorker (spot G117), gonna drive up tomorrow. A little nervous as a new trans leak popped up right before the trip but just gonna pack a lot of ATF. Excited for a nice drive and to see all you guys!
It couldn't have been more obvious, i can't believe I didn't check for it sooner, the bottom half of the twilight wasn't lighting up. Harvested an 1157 bulb from my non-running F-100 and now it blinks perfectly. Also, no smoke with the high idle this morning
I would say it has more of a sharp stink. Floor is not wet but coolant is coming out of condensation line in the firewall. I had the blower on position 3, as it does not work on high. However, when it smokes the blower motor is not on, as I usually don't turn on the air condition while it is...
No sir, I have manual AC. I don't know if this has anything to do with it, but it did start around a similar time to when I used the heat for the first time in a while to defog the window, not sure if that is a coincidence. Also, I've only been able to catch it after high idling for a while...
Okay, good point on the bulb, I have fixed that issue. About the smoke, any specific resistors I should look for? It seems to come from the black plastic near the central glove box but on the passenger side
Yeah, now that this has happened there has been a pause to my prior habits. Not a legal problem out here in the country though, I would be shocked if someone said something
Hey guys,
A new problem popped up today. I hit the left signal while turning and it just stayed on for a while. Eventually, it started blinking, but only like one blink every 45 seconds. Right side works fine, unable to test hazards as my switch is broken so if I pull it out I have to reset...
Quick question about vacuum,
On the intake vacuum tree, there are only three lines attached. One is the brake booster, one is a very tiny line that I think affects the A/C/Heat, and one is a medium size line which goes into a box on the steering column under the dash. This third line is...
I had mine on the port at the front of the carb quote close to the top, now it is connected to a port on the carb but under the throttle blades, so not straight intake vacuum, but below the throttle blades
Hey guys, wanted to let you all know that I solved the problem!
Took it to see a friend of mine the other day and I told him the issue I was having, took him about 5 minutes to realize that I had connected my vacuum advance to ported vacuum, not manifold vacuum. I also had my brake booster...
Got horn pad off and hazard switch problem fixed, able to push it back out from inside column. horn plastic piece crumbled but going to replace that soon, put wheel back on and horn was stuck on!
Thank you,
77newyorker440