Recent content by Anthony 71 Paisley

I should've been a little better with my wording. It looks like complete driver side. I haven't tried to lay them on my car to check fitment. I don't know what trim level it would've came on. Mine is a gran coupe / the mouldings I have on my car have a single stripe down the center...

I collected all the body mouldings I need for my car. Make reasonable offer. Don't want to see them get ruined in my loft. White set is complete will need to be straightened but pretty good shape. Black set appears to be complete driver side quarter panel moulding has 90 degree bend in...

I don't know where this thread left off. But yes , the bellhousing gets cutoff. I took my time with a sawzall & angle grinder. It's really not a bad job. The other option is bringing it someone with a mill , but I'm cheap and don't have patience. The bellhousing comes with hardware & gets...

Prices went up. Also , 10 or 10.5" convertor is largest that'll fit. So have to figure that in too. But no matter what you have to get convertor. . Also trans cooler lines are larger on 46rh. I went with A/N & an external cooler. Someone could use adapters to save a little JW Performance...

I did a 46rh in my 71. Cost wasn't terrible of you ask me. The hardest part for mine was retaining the factory column shifter. There's no provision on the ultrabell for factory linkage . If you have to send everything out obviously Cost would be much more. Also if you have to have the trans...

I want to say I got the material from SMS. I'm not sure if it is the same or not ,pattern looks correct. I would think the seat material would be a little thinner maybe but then probably this vinyl will be a little more durable (hopefully). I only bought it maybe 2 years ago so I would think...

I have a few yards of vinyl for my top. I was planning on using that for whatever insert on seats.

Yes that's the plan

I know this is a long shot. But I'm looking for bucket seats for my 71 Fury. I would prefer fair condition on frames and back but they will be recovered anyways to match my Paisley. Im not looking for low backs or with adjustable headrest . I'm located in Suffolk County NY Long Island so closer...

A few months back a guy on this site sold a pair of bucket seats , they were out of a 71 Fury. I was a day late , such is life. I'm looking for a pair , they don't have to be in great shape I'm hoping to have them recovered in the Paisley pattern to match my interior. I would prefer non power...

Set of Crane rockers for Mopar big block. Comes with spare adjusters. I believe they are 1.5 ratio. Will ship on buyers dime , PayPal or cash only. Suffolk County NY . 350$

I'm sure others can explain better but pretty much with a choppy idle the Fitech has a hard time getting a steady signal to deliver fuel properly. It tries to regulate to to whatever Afr parameters the user plugs in instead of a carb pulling fuel without regard. A stock cam would work...

Thanks

Yes, I'm it the limit of this convertor. I looked around a little bit for a slightly looser one I can't stomach the 1000$ price tag for a few extra rpm stall. I had Viper Transmission Parts loosen it up as much as it would go. I never ran it with the 3.91 gears only the 4.10 I was pretty...

Figured id post an update. Got the motor swung in place in Sept of 21, Long Island Needs a Drag Strip & Pete Scalzo as well as many others were able to convince the town of Riverhead to allow us to run 1/8mile unprepped track for 8 weekends of 21 . I didn't have the time to get the bugs...