Recent content by AussieB

Hi guys. Bit of a long shot here but my 1960 Windsor needs a rebuild but before going through the hassle of that I wanted to see if anyone in Aus. had one of these transmissions in working order? Would prefer a good used one so I can drive the car and get the orginal repaired later on. Thanks...

Great information Torky, thanks for letting me know about how to decipher these plates better.

Great information thank you both!

Hey guys Is there anyway to know the month of manufacture from the tags /chassis no.? Thanks.

Thanks Omni, appreciate the info. Was just watching said YouTube vids on Murray and Fletch from Australia over the weekend! So many great things in Murray's yard! Thanks again.

Thanks for the info, always appreciated. Will definitely check the rear esp. wheelwell etc. Thanks again.

Thanks Dan good advice. Gorgeous wagon, is it a '63? The one I'm looking at it's nearly as nice yours. This Windsor has a small amount of rust in the tailgate and the floor has been replaced at some point. Couple of small bubbles in rear quarters but nothing much else. Good to know about the...

Thanks for the replies guys, SGT FURY, well noted on the tank, will check if it's a good'un, Craig I'm sure I will have to speak with you at some point re. brakes. Thanks again!

Hi guys I've been looking for an Exner wagon for many years and have found a 1960 Windsor in decent condition, running and driving with a 383. I'm located in Australia so it's a hard car to find and get parts for, the engine is easy to get parts but brakes etc. are harder. Any recommendations...

Thanks for the welcome! Looking forward to some Forward Look action! Looking at posts already I know I'm in the right place, the amount of info and insight here is staggering.