bronze turbine's latest activity
-
bronze turbine replied to the thread 68 Polara wagon gas cap issue.Maybe you need a vented cap? -
bronze turbine replied to the thread 400 vs 440 in a 76-78 New Yorker - noticeable difference?.I just did a quick google search for the specs. 440: 320 ft-lb of torque @ 2000 rpm 400: 305 ft-lb of torque @ 3200 rpm I think most...
-
bronze turbine replied to the thread what is best oil to use on 1978 Chrysler with 400 engine?.I used to use VR-1, it's got all the zinc you need (better off not adding any additives to it). But, being a racing oil, it's not...
-
Just so we are on the same page, the studs press into the hub, not the drums.
-
bronze turbine replied to the thread what is best oil to use on 1978 Chrysler with 400 engine?.I've done a bit of research and I'd say that the best oil for any of these engines with flat tappet cams is Amsoil classic and hot rod...
-
bronze turbine replied to the thread If you could have.A 1983 but swapped with a 5.9 magnum engine.
-
bronze turbine replied to the thread Filled my rebuilt engine with 6 quarts including filter and dipstick says 1 qt low..I don't think the fact that it's been rebuilt would have any bearing on the oil level, unless the oil pan or dipstick have been changed.
-
bronze turbine replied to the thread I see nothing in FSM on the door stops and how they work?.I'm thinking of something later. I'm thinking of the plate with the waves on it that is pulled against a roller by a spring. A '57...
-
bronze turbine replied to the thread I see nothing in FSM on the door stops and how they work?.Probably it's the spring that's broken.
-
bronze turbine replied to the thread 727 trans pan gasket that doesn't leak??.mopar (02464324AD) (Someone please correct me if I'm wrong.)
-
bronze turbine replied to the thread 68 chrysler newport turn signal problem..Yes, the 4-way flasher is a different flasher.
-
bronze turbine replied to the thread Valve cover smoke after switching to synthetic oil.Probably your valve cover gaskets are leaking oil on to the manifolds.
-
bronze turbine replied to the thread 68 chrysler newport turn signal problem..I can't think of any reason why it would make a difference if the engine is running. Key in the on position with the motor not running...
-
bronze turbine replied to the thread Wheels and tire ratio question.245 is the width of the tire. You would need to know the diameter vs. the diameter of the factory tire. Then, there's calculators on...
-
bronze turbine replied to the thread 1968 Chrysler 300 hub caps fits 1970 Chrysler 300?.I don't believe the 1970 had the option of 14" wheels. Could you put 14" wheels on? Maybe if it didn't have disc brakes. But, 14"...
