Recent content by Dodgeboy38

I am looking for 1 of 3 of these blocks. If you have one or know where I can get one please let me know! They are no longer available which is making this hard to find.

245/40r18s upfront and 275/35 r20 on the rear, I have 4.5" back spacing though

I am looking for an interior piece, it mounts under the steering wheel and mounts the vent levers that controls the floor vents. I have a 67 fury III

I am looking for the piece below the steering wheel that holds the vent controls, that operate the feet mounted vents. Prefer copper colored but any color will do.

Got the new wheels and man does this thing stop. This is hands down the best thing going I have done, taking off the ssbc kit and putting the wilwoods on.

Thanks everyone. The Kit I bought was this http://www.summitracing.com/parts/wil-140-15198-d. The Hp Manifolds match the HP motor!! I finally got the brakes installed and man are these things massive. I found out the hard way that the 15s I have will not clear the caliper, ignore the tire on...

So after a year of having the car down because I hated the way the brakes were. I decided I needed to put something better on, and it arrived today!! Hello wilwood 6 piston brake kit. I got 12.19" drilled and slotted kit. It should match the master I put on over winter. I will post updates when...

I love that stance! What size wheels are you running? if possible can you send me the specs on them?

i am looking for a piece of trim that attacheds to the hood. It attaches to the underside of the hood by the latch. To fit a 1967 fury III.

what are the specs on the wheels?

so i just ordered a power disc brake kit. so i figured i will need a new set of wheels to go with it since the stock ones are 14's. I would like to run a 15 x8 if possible. I would like a wider rear set of tires. will 255/70's fit, i see some one said they heard that someone had some rubbing...

c2c fabrication. i trimmed it down to only replace the heavily rusted areas. http://c2cfabrication.com/chrysler/plymouth/fury/

thank you sir!

nice find! best advice I can give is make it your own!