Just replace gaskets, eliminate leaks..clean and rebuild the carb..meausure vacuum and fuel pressure. Adjust the ignition timing and a/f ratio...vacuum gauge is a good analysis tool. If there are no other issues..(lifters/ valves) you should be fine
Weiand action plus...I am going to install that one on a 383 b-body with factory a/c. First issue...outer mounting holes. There is not enough space for the screw heads..That means. Grinding all around flat.
Second issue...on my casting. Missfitment on the intake runners which are going to the...
Thats correct. You can use the OEM dipstick and refill to the dipstick marks. The spacer is needed as the oil Filter should be at the deepest point of the pan to avoid suck in air..additional benefit decreasing the temperature. Use a gasket between the spacer and valvebody.
Hi folks! I am looking for a driver side headlight bezel without dents...Taille lights left & right lenses without cracks..wheel moldings and a dashboard pad which is not broken. Hard to get parts..
And a seat release knob.
Thx
Thanx..I am abroad and will use them only on car shows. According to my cars history. If you recognized the validation number... it says 3831967..67 for the year and 383 for the engine.
Ok..some guys will hate or advise me what is legal and illegal. I am really take it serious...and as the original cali plates didnt came with the car there was no other chance..as to reproduce them from steel sheet. They look not bad. So thats my first restoration action.
The sidemarkers are from the 68 fury year. They were already installed on pictures from 1999. I guess as the car was built in october the 10th..that the first owner just installed them between 67-99
Great looking Fury in PP1☺
I will need some extorior trim parts moldings. Like wheel moldings..driver side front light bezel (without dents) can polish / work out the patina..☺ Thema
And of course some Taille light lenses☺