Frank Odenthal's latest activity
-
Frank Odenthal replied to the thread Is there a “good enough” when lining up oil holes in cam bearing installation?.Engine builder pressed in the cam bearings, cam fits in very nicely, but he had problems with alignement of No. 4. The passenger side... -
-
Frank Odenthal replied to the thread Accursed Rear Drivers Spark Plug.I found out a 4 inch Long rubber hose ( not sure about the diameter) that fits tight on the ceramic insulator is the easiest way to...
-
Frank Odenthal replied to the thread 440 TNT rebuild.Are you Running .520 Lift with a flat tappet or Roller cam ?
-
Frank Odenthal replied to the thread 440 TNT rebuild.911-16 are fine for cams below .500 lobe Lift. 925-16 is the comp cams double spring. I beliefe 440Source is using a different Brand...
-
-
Frank Odenthal replied to the thread Issues with cam bearings and clearances. Cam will not fit..The FSM says camshaft bearing diameter „After reaming „ Was that the standard procedure in the engine plant back then, or is this the...
-
Frank Odenthal replied to the thread Where to attache a tow rope ?.what about fabricating something and bolt it under that nut here, which has a high torque applied to it ?
-
-
Frank Odenthal replied to the thread Where to attache a tow rope ?.Okay, that's a nice story with a happy ending. What a good thing a breakdown can be
-
Frank Odenthal replied to the thread Where to attache a tow rope ?.Dielet.
-
Frank Odenthal replied to the thread Where to attache a tow rope ?.Thank you for response, I did the same but it is hard to reach the K Frame Beside the Oil pan with the car on the ground, and you should...
-
Frank Odenthal posted the thread Where to attache a tow rope ? in Early C Bodies - The Slab Side Years.Where do you attach the tow rope to pull the disabled vehicle out of the danger zone or on a Trailer? Does anyone have anything mounted...
