Fury1969WI's latest activity
-
FFury1969WI replied to the thread Is there a “good enough” when lining up oil holes in cam bearing installation?.hmm... maybe something like this? 12" Right Angle Flex Shaft
-
FFury1969WI reacted to Frank Odenthal's post in the thread Is there a “good enough” when lining up oil holes in cam bearing installation? with .Thank you, I will ask my dentist to visit me at Home :-)
-
FFury1969WI replied to the thread AC fan slow?.Does this imply (infer? I can never remember!) that it's time for a new fan / blower motor? "... when the fan motor pulls a...
-
FFury1969WI replied to the thread Is there a “good enough” when lining up oil holes in cam bearing installation?.if it were mine i'd want to have those oil flows to the valvetrain even. As long as you plan to clean the block really good again i'd...
-
FFury1969WI replied to the thread Hit n run door dent.Nice example of what's possible with paintless dent removal;
-
FStroked a 383 to 496 to go in my factory 383 4 speed fury 3. Getting excited!
-
FFury1969WI reacted to Cianmini1's post in the thread FUEL ISSUES WITH MY 65 Chrysler Newport 383 with .Thought I’d fill you guys in! Turned out to be a bad fuel line was only put in last year but seems it must have had a pin hole in it...
-
FThought I might start a thread with my progress so I can keep track of it. I welcome any and all advice. The first set of photos are...
-
FI can always look and ask around. Lots of folks have stuff stashed away for a rainy day. Its a long way out before I get the trim back...
-
FDo this, all you or I would do is screw it up worse. there is a science about how this is done. You may need to talk to several of...
-
FFury1969WI replied to the thread Door Jamb U seals for rear window 1969 Polara.Hardtop/Convertible? Similar Fury or Chrysler seal (probably 69-73, likely 67&68 too) will be the same. Also, as suggested above...
-
FFury1969WI replied to the thread Hit n run door dent.That sucks, I'm sorry that happened. Maybe inquire with your local paintless dent removal franchise, they can do some amazing things...
-
FCorrect
-
FHijack away! Always new things to learn. Thank you to everyone who replied to my post.
-
FFury1969WI replied to the thread Carb choice for a 440.I think "12 o'clock" positioning is for when doing a horizontal pipe run installation. Position doesn't matter so much in a downpipe, am...