Recent content by larry
-
L
Tool C-4113
The shaft has not been removed. The Mopar shop manual for the car which I bought when I bought the car new says that once you get the lock plate off you can access the ignition lock. This is a 1974 Dodge Charger. It does not tilt. I have tried a C clamp setup but it wont budge. Do you think...- larry
- Post #11
- Forum: Later Model C Bodies - "The Formal Years"
-
L
Tool C-4113
Here is a picture from the Shop Manual for the 74 Charger:- larry
- Post #9
- Forum: Later Model C Bodies - "The Formal Years"
-
L
Tool C-4113
It is not a drift pin or roller pin but a solid steel pin- larry
- Post #8
- Forum: Later Model C Bodies - "The Formal Years"
-
L
Tool C-4113
I need to replace the ignition lock. It is VERY sticky and hard to turn although it still works. Here is a picture of the C-4113 tool:- larry
- Post #7
- Forum: Later Model C Bodies - "The Formal Years"
-
L
Tool C-4113
I am looking to rent or buy the 1974 Dodge Charger steering wheel lock plate pin removal tool. It is Mopar special tool # C-4113 . Any idea where I can get a hold of one?- larry
- Thread
- Replies: 12
- Forum: Later Model C Bodies - "The Formal Years"
