Recent content by mbnewp

Real clean, real clean.

I hate how dim my panel is and even tried LED bulbs still too dim. In the middle of rewiring the whole thing with a kwikwire kit and always looking at led strips rather than the current set up for the same reason haha

Thanks! Thanks! yeah one day at a time. This is my first attempt at such a project; so learning one thing always leads to another. That photo was a year back haha ...cold winter. Its much higher now haha. I do notice a faster response - much faster. I get that nice torque "pull down feeling"...

Hello all - i lurk on here for info and from time to time ask a question or two. Wanted to share some recent changes on the ol girl. after a partial scrubbing to see what i was working with 2bbl 383 becomes a 4bbl 383 next step is the rewiring - harness arrives this Friday so sometime...

Hells yes. Problem solved; to a point. Turn indicators are still not working but I was able to track down the short to the dome light thanks to the diagrams provided above. As long as my rear and brake lights are working, I am happy. I will solve the turn signals later. Read a few threads on...

thanks Big John. the linked helped quite a bit. looking forward to getting back out there.

Long story short, here I am with the blue, red, and a yellow wire to which I am unsure where they go. Blue wire I was able to find the end for. It loops the left to right rear lights connected and got my rear and brake lights back going. Since then my rear signals fail to signal and my dash...

@MYSINBIN amazing! thanks

Bottom (left side) out and clear right side half done. Thanks everyone

@SF-66TC noted. i shall take the precaution thanks for the tip

Yes sir just reference; mine is the bottom photo. But you have gems of information here in your reply. Understood. Yeah I am not even certain how anyone would feel good about that current set up .... without a note.

I think prefect fit has me with price and quanity of length ratio. But i will certainly look into these other options. Thanks I think i am going with newstalgiaparts on the headliner. Anyone have experience with them?

Many thanks again. Yeah the problem is my lack of the keywords in my searching. Not working from a book which i suspect may help my case a lot then whimpering on google when thems like seal, coupler, rag joint dont turn results that look as blown out as mine haha, tough to compare which is...

Thanks Fury Fan ! So, how do I go about removing this sommagun? I seem to be working with a tough particular version of said rag joint. I loosened up the nuts on the bottom half of the coupling but am at a loss of how to actually remove them since the spindle inside the cleat seems to move with...

*BUMP* Pretty thankful once again for this forum, another life saver here. Many thanks Wollfen !! Question about the rag joint - assuming from the photo here the orange section is that rag joint, correct? I noted some discussions of the angles on the earlier images. Should there be no...