mgm1986's latest activity
-
MHi everyone , hope all is well . Made a little progress on the 300 today after fighting off the crud for the last couple weeks . Most...
-
MAnother pool noodle on my ancient floor jack. Keeps the handle from banging the car. Note red lug nut holder.
-
MMaybe not a tip, but more of a "How did I get along without this?" This screwdriver has turned out to be really handy. It's not...
-
MScrewdrivers have this specific shape for a reason:
-
MWhen I was swapping the carb and manifold, I changed the fuel line from the pump to the carb. Pulling the alternator, I noticed that...
-
Mmgm1986 replied to the thread Electrical opinion.The cooler the car the pricier the part! :lol:
-
MIf the odometer is working, it would seem to me that the gear and cable are good. I haven't had a speedometer apart in decades, so I...
-
Mmgm1986 replied to the thread Speedometer Not Working....This is what happened to me when I put my dash back together. Odometer clicked but no speedo. Turned out the cable wasn't fully engaged...
-
Mmgm1986 replied to the thread Electrical opinion.That is what I did. I started by carefully removing the engine wiring harness and labeling everything. Then I laid it out on a piece...
-
Mmgm1986 replied to the thread Electrical opinion.Maybe the wiring diagram would show the size of the fusible link? You can probably source another bulkhead connector on ebay if you...
-
Mmgm1986 replied to the thread Budget 440 headers.I installed a set of Hedman mid-length headers in my '68 300. I had to tighten them a couple times after a few heat cycles but haven't...
-
-
MI think I fixed the issue. Poor dash ground. But I ran out of gas hahaha
-
Mmgm1986 replied to the thread Electrical opinion.@1970FuryConv Makes a great point. A simple check could also be to hook a battery charger up which should bring the voltage up closer to...
-
Mmgm1986 replied to the thread Journey Begins 67' Fury.As a newbie to the game myself the best advice I would offer; don't start on too many "projects" at once. Unless you have PLENTY of...
-
Mmgm1986 replied to the thread Electrical opinion.If you can test the Volt regulator that might be helpful. My VR worked when I held it just right but most of the time it just passed...
