Recent content by peterh

Thank you

Thank you so much for taking your time. Here is a photo of the push rods showing the tip.

Thanks for your reply, David. The cams look good, so does the lifters convex surface. As I interchange the lifters, the problem follows. I just had a look into Kanters Website. They have lifters, apparently suiting the engine. Their geometry is slightly different. They don't have the tapered...

Your link already helped me to find out, that the adjustable rocker arms fit the same shaft as the non adjustable ones. This enables me to make the conversion, in case I can not find suitable hydraulic tappets.

Thanks for the welcome and for your kind offer. For the moment I am trying to solve the valve tappet issue. Some hydraulic tappets leak to a level, that they barely lift the valves. Mopar No 2808569 seem to be correct replacements. Unfortunately those are very hard to find. There are suitable...

Thanks for the link. I will try....

Thanks. An impressive collection!

Great! Do you have pictures?

After looking around for details of the 53 to 67 A block engines I am happy to have found C Bodies. I am probably kind of a 'special guest' within your group, as I do not own a Chrysler car, but a boat with a Chrysler engine. This one I built in the early 80ies and was happy to find the...