propilot74's latest activity
-
PI run 20w50 in my 383. Cold start gives 75-80 psi. When really warmed up 50 to 60 psi at approx 70 mph 30 tot 40 psi at idle
-
Ppropilot74 replied to the thread Reman squareback alternator internal short?.Thank you! I actually have the service manual downloaded to my PC. I'll pull it up later and find the relevant section to print out...
-
Ppropilot74 reacted to Big_John's post in the thread Reman squareback alternator internal short? with .While the rear bearing is pressed in, the front bearing is just held in with a spring clip. Rear bearings rarely fail, but they can...
-
Ppropilot74 replied to the thread Reman squareback alternator internal short?.What do i use to drive the old bearing out and the new one in? Just a couple of appropriately sized sockets and a mallet? (I'm just...
-
Ppropilot74 replied to the thread Reman squareback alternator internal short?.Since there was no core required for the new alternator, I may try and repair this one and keep it as a spare. I've never changed one of...
-
Ppropilot74 replied to the thread Reman squareback alternator internal short?.There is under one of the terminals (the one that will still accept a spade connector), the other one has a metal washer under it, which...
-
Ppropilot74 reacted to Vaanth's post in the thread Reman squareback alternator internal short? with .With the new information, the alternator sounds okay.
-
Ppropilot74 replied to the thread Reman squareback alternator internal short?.OK. Now I feel like a complete idiot, but I guess this is how we learn. I was measuring using the screws on the brush terminals...
-
Ppropilot74 replied to the thread Reman squareback alternator internal short?.Thanks, I will be returning it tomorrow.
-
Ppropilot74 reacted to MoPar~Man's post in the thread Reman squareback alternator internal short? with .I'm looking at a '73 service manual, and the test procedure shows one of the FLD contacts jumpered to ground, but it doesn't go into...
-
Ppropilot74 reacted to Vaanth's post in the thread Reman squareback alternator internal short? with .With the measured numbers, that alternator is bad. It may have the shorted brush for the application use, but the rotor is definitely...
-
Ppropilot74 reacted to Vaanth's post in the thread Reman squareback alternator internal short? with .With the listed measurement results, the rotor wiring is shorted to the core, and subsequently to the alternator housing. Or one, or...
-
Ppropilot74 replied to the thread Reman squareback alternator internal short?.I just rechecked, and both field terminals read 0.4 ohms to the case, and the Bat+ is showing approximately 1000 ohms to the case...
-
PMy 67 Monaco is in need of a new alternator, the bearings are shot and it's growling something awful. I purchased a reman unit from Napa...
-
-
Ppropilot74 replied to the thread Welcome, propilot74.Thank you! Glad to be here!
