Recent content by Rainy Day

Jim, these will fit on all 1965-1973 Dodge Chrysler Plymouth C bodies as long as customer uses the drum brake 2 bolt lower ball joint. The factory 1966-1968 Budd disc brake 4 bolt lower ball joint will not work for this setup. Hope this broadens your audience. GL with the sale.

$650 shipped

@Toolmanmike

This sounds an awful lot like similar dealings with Martin Lackner.. Now if it is him you fellers are in the same state.. Dude has more stories than a fairy tale book. GL.

The green 73 above is mine. I'll check shipping cost and let you know. I have shipped out several rear windows.

I have a good used 68 fury filler neck. I am located in San Antonio, Tx area I can ship if needed.

These guys are the best around period. Located in San Antonio, Tx They did an orig 2 piece shaft for a 65 fury a few years back and custom built it as 1 piece. Owner was located in Canada. Driveshaft Specialist Home

When I replaced mine I did not split the hangers apart, I drove them off the bar with a pickle fork and hammer sideways and slid the new bushings over the square end 1st then knocked the bushing and hangers back together. Just use a block of wood to hold the bushing still while you tap the...

I have been using type F exclusively in my Mopar transmissions. Walmart carries it and has continued to serve me well. 0 issues.

Before we chase this too much.. Please confirm new one and old one are both 1 or the other. They look very similar, and both used the same cap, they do use different brackets and often times parts stores mix them up.

Both corners are in very good condition. Very light surface rust on backsides only. They should clean up very well.

I have a good used pair. I am located in the San Antonio Tx area. I can ship if needed. 1967's were chrome. 1968 are painted. Mine are painted.

Pm Sent

I have a good used rust free 1968 Fury fender in the San Antonio, Tx area

Here's a nation wide salvage yard lookup that shows this manifold in stk. GL