Recent content by Ryan Taylor

Any updates on the vehicle?

What you mean by slab side year section??and they are old Hoosier dirt track tires I tossed on for rollers but are growing on me. They are 8.0/27.0-15

This will be how I fuel up the car. Since it’s a side full tank. This is a 1979 triumph spitfire fuel cap setup

The fuel tank I am using is out of a 93-98 jeep gran Cherokee(ZJ).so that the stock pump will place in. No need to worry about correct line pressure if it’s factory. And I’ll most likely use the truck gauges because I currently can’t find the listing to the Amazon gauges.

I believe the aftermarket gauges will work if they are the electronic ones. I was looking at a set of 6 on Amazon for 240.00.

I’m working on this 67 Plymouth. That I will be putting a 94 Ram 8.0L into. Currently working on putting a fuel tank into to run the original dodge truck fuel pump. Than I’ll be moving forward on the lines. before I install the motor and trans. So I have room to work with.

That looks like a good way to go but I believe the dodge trucks have a speed sensor on top of the rear axle pinion

How do/ did you go about wiring the dash to have gauges?

Any more progress on the swap???

I recently purchased a 67 fury 4 door and plan on putting my v10 motor from my 94 Dodge Ram. Location: United States