Recent content by SeaFuse

Have this 26-inch cooler that came with our '72 Fury. Wanting to know who the supplier is. No marking on it. Fits well with no modifications and functions fine. Uses factory molded hoses (360). Trying to track down supplier so can see if a shroud is available for it. OE shroud does not fit...

No, it does not mean that.

Article pic is from. Page 3 photo lighting is pretty bad.

I've never seen a clear picture of a 72 Fury with the Formal top, until now. Kind of like the rear quarter styling, versus the 72 coupe's large hips. Formals must be rare must be rare models. I think the brochure photo below has the Formal and Hardtop descriptions mislabeled.

Bumping for assistance on gasket source . . .

Recently installed 235/75/15 tires on my 72 Fury and had to unbolt shocks to drop axle down enough to fit wheel/tire. Lots of room in wheel well once installed. Removing previous 225/75/15 was tight too. Assuming this is not normal. What is correct compressed / extended length of the 72 Fury...

The color combo is going to limit the price this one gets. 72 Gran Coupe is one of my have-to have-vehicles and are nearly impossible to find (outside of Deutschland). Pay more than it is worth type of car for me. But man, that triple earth-tone would always give owner's remorse vibes, unless...

Are these 5x5" PC road wheels or are adapters bring used?

Hello - looking for a source of the mounting "gasket" for the above mirror. I do not see the gasket in factory parts books so assuming they were normally supplied with the mirror. Below pic of same mirror for illustration (72-73 Fury?). I see some A/b/E body mirror gaskets being reproduced...

I recently cjecked out this bumper and it is quite nice. Better than typical hi-mile “driver” quality. The grill and rear bumper from same car looks pretty good too.

Anybody here have experience with the fit and sound dampening quality of the pre-cut kits sold by ACC? Is the "EVA material" dampening performance on par with of bulk product from 3M (EDP1029), Dynamat, hushmat etc.?

Thanks. Your link went to a picture. Here is link I think may have sent. Actually shows 2 different widths for 70-71 but this could be an error https://www.hemmings.com/stories/mopar-8-3-4-inch-rear-ends/

Are all 69-73 C-body 8 3/4 housings the same flange to flange, and spring center widths? I recall reading the 72 Fury axle housing flange distance was widened but may be misremembering this. DC chassis book does not mention c-body 8 3/4. Thanks.

Pm sent (localish).

Looks similar to the 17” vision shift. But different. 17” has 6 kidney holes and 15” with five. There also these very modern styled grey Kidney wheel.