I didn't get any photos of the installation. It's really easy though. A couple of measurements for the frame rail brackets. It comes with self tapping bolts but I added some welds for piece of mind. The other end sandwiches between the leaf springs and perch.
Anyway back to headers.....
I have aluminum edelbrock rpm heads which have angled plugs. Sucks a$$ even worse. I have the shortest plug I can find with a ceramic boot and a heat sleeve. They're coated hooker headers. Cylinder #1 is the worst. I may have to dimple it a little bit.
Couldn't find the skirts. Sorry for the crappy picture, but I think it would be too close for my liking. I can fit more rubber under there though, once these wear out.