stu’s68furyiiirat's latest activity
-
stu’s68furyiiirat replied to the thread Speedogear ?.I believe it's a 1975 transmission. It has a off white Speedo gear in it -
Google speedometer gear calculator. It's more in depth than you might think. Tire size, drive ratios, rpm at cruising speed, all that...
-
That is a very small diameter tire for any C-body. Specs from several tire brands at Tire Rack show it has about the same revs/mile as...
-
I have stock transmisson A727 small block I like to figure out which gear I need for my select tire size 225/50/17 stock rear end etc.
-
stu’s68furyiiirat reacted to My three 67 Polaras's post in the thread One more time disc brakes with .Hey did you figure out anything on this swap as to whether or not it will work?
-
CENTRIC 12163021 CTEK; Rotor & Hub at Rock Auto for $61.89 ea
-
stu’s68furyiiirat replied to the thread One more time disc brakes.No not sure
-
After I installed the old Mopar Perf ignition kit, I started the car 4 consequtive times. On the 5th try, nothing. Got out the meter...
-
stu’s68furyiiirat reacted to michiganhotrod1's post in the thread 318 freeze plug 1968 Plymouth fury III with .Performance Tool W89737 Performance Tool Frost Plug Remover/Installer Sets | Summit Racing I've done a few of these jobs in my day. The...
-
stu’s68furyiiirat reacted to Mr onetwo's post in the thread 318 freeze plug 1968 Plymouth fury III with .good quality set of plugs Mancini Racing Brass Freeze Plug Kit
-
stu’s68furyiiirat reacted to david hill's post in the thread 318 freeze plug 1968 Plymouth fury III with .To avoid revisiting this again I would recommend replacing all freeze plugs. w/ the age of the engine being a 1968, total freeze plug...
-
stu’s68furyiiirat replied to the thread 318 freeze plug 1968 Plymouth fury III.They are right above oil pan so o am going to pull the motor and do them all to be safe
-
stu’s68furyiiirat reacted to Toolmanmike's post in the thread 318 freeze plug 1968 Plymouth fury III with .The core plugs in the heads rarely leak. It's easier to get the casting sand out would be my guess.
-
stu’s68furyiiirat replied to the thread 318 freeze plug 1968 Plymouth fury III.These are the ones on the side of the block I think my ones in the rear are bad as well
-
stu’s68furyiiirat reacted to twostick's post in the thread 318 freeze plug 1968 Plymouth fury III with .If that's a small block, do not put the trans back in without first replacing the the freeze plugs in front of the flex plate. DAMHIK...
