Search results for query: HOSE!

Oil, power steering fluid and gear lube has been ordered, also more parts from Vans Auto. The heater hose nipples will need some persuasion to leave their home for the past 50 years.

I think I have a box of the bigger vacuum hose, let me check tomorrow. I'll just send you a piece, because I know I haven't ever used any of it. I got it a long time ago. And it is the heavy wall hose.

I'm working on a buddies 1968 Imperial and as is with most old cars its a bit of exploration and guess work as not everything is the way the factory did it. There is a rubber hose that exits the firewall by the brake booster and then is just tied up in the harness and not connected to anything...

Hi Josh, What part number did NAPA hose have? Thanks! Ben

Better get this brake hose replaced pronto. Cracks/splits in the outer sheath let debris in, and as the hose flexes, it can abrade the inner material - which holds the pressure. Would be prudent to replace all 3, although cracking the fluid system can often snowball if bleeders/tube nuts don't...

Thank you! This explains everything I needed!

Did you get the fresh air intake hose that you were looking for?

Its further than 12 inches, i also installed a one way check valve so it keeps fuel primes in the hose "drain back" out the hose into the tank. Im not sure if that works as intended as the pump sometimes still clicks VERY loud, i think the checkvalve might stick every now and then... I run a...

It's attached with a clip.

Next were the vacuum lines. All you need to do is follow the routing for the manual AC controls in the service manual. The vacuum servos are all the same. I bought new vacuum lines as I didn't want to hack up the vacuum hose harness. I wanted to keep everything as intact as possible. Not...

Jeremiah, turn the radiator hose clamp around before you slit the artery on your forearm and bleed out before you get to a hospital, where in the NW jungle do you live? .growing up near the silver dollar bar, Racine County Mike

I had a brake hose fail on my New Yorker. The car pulled to the right when braking. The left brake hose was nearly completly clogged although the rubber still looked good on the outside. No brake fluid could reach the left caliper. I think a new brake hose should solve your problem.

Might there be some faded stamping numbers on the hose themselves? Just curious, CBODY67

If your REALLY determined to replace that TRW with another pump, get the Saginaw, which has abundant parts, brackets et al, THEN SELL ME THAT TRW!!! I'll rebuild it and make it work.

I switched from thinking the intermittent rough idle on my 75 New Yorker (440 engine) was due to carburetor problems to thinking it was due to vacuum problems. I found 2 possible sources of vacuum leaks. The first pictures show the vacuum tree at the back of the engine where the power brake...

I used to live on Kraut Rd in Franksville right off I-94@Hwy 20. I moved to OR for my job in 2008. We are 60 miles North of the CA border. Good eye on the hose clamp. I'll correct that right away. Speaking of hoses...does anyone have good part numbers for the upper a lowers?

Does the gas tank need to be dropped in order to remove the fuel level sensor in the tank? If so, are there any other maintenance items that should be done at the time? I imagine that the vent lines should be replaced - is there a recommended hose type? Can the sensor be tested without dropping...

Years ago I used seafoam in my 1988 corsica 4cyl 5 sp. Used a big vacuum hose and let it suck it in, then gave it a good dose to stall it out. poured the remainder in the tank. Left it sit for a while then took it for a drive. I no longer had to drop down to 3rd gear to climb the one hill. I...

Are you leaving the single master cylinder or going to a dual? Sometimes those older cars like the 1964 with a single reservoir will gravity bleed, that's a good thing. So just keep the master cylinder from going dry and it will almost bleed itself. One bleeder open at a time with a hose...