Search results for query: HOSE!

I would replace the fuel filter, 1st. If it's gurgling that could indicate a problem. NAPA 3032 is 5/16 line and good quality. It has an arrow on the side because it is one-way. I would then disconnect the fuel hose at the carb. Hold the fuel hose in a jar. Have an assistant turn the ignition...

Hi John What rear brake hose brand and part# did you use? Thanks, Ben

Well, I got most of the new AC lines mocked up (not crimped yet) but I was shorted two fittings for the hose going from the compressor to the condenser, so that's not ready yet. Anyway, it was about $200 for the hoses and fittings and $100 for the crimping tool. Almost there! All of these...

Hello, I have a 1967 Plymouth Fury III 383 V8 Commando with A/C. I’m working on fixing a coolant leak from the lower radiator hose when I noticed there was coolant dripping from the third belt closest to the oil pan. Its dripping from the belt and the circular thing (I’m not sure what it is-...

If you look in the picture you can see one of the vacuum tubes that is disconnected. it also looks like my plastic hose coming through the firewall is broken on the end. like it should be attached to something.

THANK YOU for raising that point! Swollen hoses devil many drivers long before they're discovered. The REAR hose often causes the most damage, as people neglect to change it when they change the front pair. If ONE hose has swollen near shut, its a good idea to change all 3, especially if one...

Oil, power steering fluid and gear lube has been ordered, also more parts from Vans Auto. The heater hose nipples will need some persuasion to leave their home for the past 50 years.

I think I have a box of the bigger vacuum hose, let me check tomorrow. I'll just send you a piece, because I know I haven't ever used any of it. I got it a long time ago. And it is the heavy wall hose.

I'm working on a buddies 1968 Imperial and as is with most old cars its a bit of exploration and guess work as not everything is the way the factory did it. There is a rubber hose that exits the firewall by the brake booster and then is just tied up in the harness and not connected to anything...

Hi Josh, What part number did NAPA hose have? Thanks! Ben

Better get this brake hose replaced pronto. Cracks/splits in the outer sheath let debris in, and as the hose flexes, it can abrade the inner material - which holds the pressure. Would be prudent to replace all 3, although cracking the fluid system can often snowball if bleeders/tube nuts don't...

Thank you! This explains everything I needed!

Did you get the fresh air intake hose that you were looking for?

Its further than 12 inches, i also installed a one way check valve so it keeps fuel primes in the hose "drain back" out the hose into the tank. Im not sure if that works as intended as the pump sometimes still clicks VERY loud, i think the checkvalve might stick every now and then... I run a...

It's attached with a clip.

Next were the vacuum lines. All you need to do is follow the routing for the manual AC controls in the service manual. The vacuum servos are all the same. I bought new vacuum lines as I didn't want to hack up the vacuum hose harness. I wanted to keep everything as intact as possible. Not...

Jeremiah, turn the radiator hose clamp around before you slit the artery on your forearm and bleed out before you get to a hospital, where in the NW jungle do you live? .growing up near the silver dollar bar, Racine County Mike

I had a brake hose fail on my New Yorker. The car pulled to the right when braking. The left brake hose was nearly completly clogged although the rubber still looked good on the outside. No brake fluid could reach the left caliper. I think a new brake hose should solve your problem.

Might there be some faded stamping numbers on the hose themselves? Just curious, CBODY67