Search results for query: *

Where did you find it

Yea I know you said 2-door. Here's one for sale in Port Alberni BC for $24k, turnkey (no work needed): There's also a 2-door sedan in Sterling Heights MI for $6900 (a bit rough but it's all there, 440 running). You want info on that one?

Agree. Have had the same experience. Losksmith shops are more money, however when you factor in the time for recutting, travel, time, etc. The locksmith is worth the money.

Easy, to do yourself, with just a new master cylinder and some brake line. On your stock distribution block remove the rear brake line and plug that with a flare plug fitting. On your new master cylinder take the line that would feed the rear brake and either use a union or make a new line to...

They probably corroded from sitting. This is pretty common on vintage parts. Dave

Much time wasted today and only discovered the problem after I ran out of daylight so I will continue in a week.. But to the point, I bought a set of NOS points Chrysler brand. New cap and rotor. No spark. A bunch of back and forth and swaping on the old cap and rotor. Finally removed the new...

If you read the add im looking for a 2 door hardtop or convertible

There's a 4-door '65 300 for sale in Grandby Quebec for $12k (on fecebook). (question - how do you search an entire state/province, or country, on FB marketplace? I can only see how to search a specific city + radius).

Are you using the same coil for both systems? Have you verified that the coil you are using is of the correct resistance? I made my own electronic ignition using an oem distributor and a gm hei internal module mounted on the core support. Super cheap and readily available. Its an option but...

I’m new to the forum, not sure how to navigate. I have a 1978 New Yorker Brougham and I am trying to remove pass front door motor ( I believe the plastic gears are in need of replacement) My regulator and motor assembly were held in with crush style rivets, I have drilled them out and the...

I think that Edelbrock kit has too much cam for what you are doing with a 383. Start by telling us what car it is going in as well as the rear gear ratio. How do you drive the car? Short trips,weekend fun,Long trips? What do you expect it to do?

The Blohm & Voss BV 222 Wiking was a massive German flying boat developed during World War II. It was the largest Axis aircraft of the war and one of the heaviest aircraft ever flown at the time. Designed for long-range maritime patrol, transport, and bomber roles, it was intended to support...

Got a link?

60 is different from 61. early 61s had gen bracket cut off always thought that was a misleading thing until i came across a original owner 61 g conv with the original owner and his car had them also have those as well remember 60s had a gen 61s had a alt

That cam bearing bare tool cost more than the motor lol. I hate the rubber sleeve style that nearly every vendor is pushing these days, but a plain solid shaft with the proper size mandrels for your given engine puts them in smoothly without beating on anything too hard. Speedway Motors has...

the fact that they can get even close is really cool! I was thinking that cool part of the interior would be gone forever if I replaced that section. Thank you!

I would stick with the points they last 20 thousand miles and are cheap to replace

Madge Motors and Breakdown Service, Grote Street, Adelaide, south side, corner of Moonta Street, July 5, 1924. BP service station, Narooma, New South Wales, 1976 Crown St Wollongong NSW, Max Dazeley’s garage, Main Road, Penguin, Tasmania, circa 1975