Separate names with a comma.
When I got my recent 69 Polara it had non HP manifolds on it, it was the original engine and it is an HP 440 car, for some reason they were...
My 69 used the ones I posted [ATTACH] Alan
It replaces the guts on a stock mount. [ATTACH] Alan
Use this and it'll solve your problems. Energy Suspension 5.1101G Performance Transmission Mount | eBay It replaces the rubber in your mount. Alan
Sounds silly but make sure there isn't two gaskets there. I don't see how the gasket in the filter could get blown out. Alan
There are gauge repair shops out there, North Hollywood Speedometer Redline Gauges Are just a couple. Alan
This is what I was told as well, the best way to calibrate a speedometer is getting the odometer correct over a long distance (50-100 miles) Alan
If you look in the Factory Parts Book there is a table in the fuel section. For 69 it appears they are different. Alan
This is what you want, replaces the rubber on an original mount, no worry about the mount coming apart. Energy Suspension 5-1101G Bushing...
1969 CHP Polara [ATTACH] Alan
My 440 has one, The 69 Polara with a 318 had one. Alan
Your local machine shop, take a good clean one in or both the z-bar and the bracket. I replaced the pins that the cables attached to on my heater...
Even with a solid mount on just one side? The last time I had a failed mount was in 1985 on a 318, I'll deal with it when the time comes, a lot of...
In the front I put them under the lower control arm socket (where the torsion bar goes). In the rear I put them under the differential housing....
My 69 used the second one. Look at your car and see if it has the holes for the extra bracket, someone may have put the wrong one in years ago. If...
Just looked in parts book, Part number 6026697 (best I can tell) Looks like Len Dawson has it. Adult Toy Department (Cars) - Len Dawson's...
They will slip off if worn or not position properly. Mopar probably doesn't have a separate number for it. Alan
Simply rod-clip Using that search I found this, not saying will work, might take info to your local NAPA Corvette Clip Accelerator Cable Ball...
Switch is fine otherwise it wouldn't start in neutral either, just needs adjusting, maybe a 1/16"-1/8" Alan
Mopar Power Brake Vacuum Fitting Port Intake Manifold AC Air Grabber GTX Cuda | eBay Alan