Separate names with a comma.
What are you asking and how do I contact (PM) you? I've never used this feature cause I guess I never had to.
Left and right required - condition doesn't matter if rusted.
Clay, I've been looking for a set of hood support hinges (arms) for some time now. The arms that the hood torsion bars lock into. Any condition....
There is another solution you may look into. Remove and inspect the tank thoroughly. If it's not too bad try a cleanup at a professional shop. If...
Is it just me or is this site becoming a private E-Bay. Sure see a lot of For Sale adds and very few discussions about C-Body issues.
You'll have to either have that one repaired or a new one made. Some have used fittings from "Pypes" or "Magna Flow" to fabricate their new filler...
Maybe not! Does Nike Factory Store offer discounts to military families and veterans? — Nike Factory Store Forums
So are you buying or selling them. The post is a bit of an oxymoron.
Just went through this same situation on a 66 Imperial. It turned out that the clutch bearings were toast and seized when they got hot. The bolt...
Not to worry because gravity is at work here. The fuel at the filter is draining back a bit because the tank is lower than the engine and liquids...
Ross has a good suggestion there but you would have to ensure the replacement floor is in very good condition and cut exactly where you want it....
I'm a proponent of "do it right the first time" so here's my solution. Siphon the tan to about 1/4 full. Using a hydraulic jack with a square...
I would think that there was an issue some years back and the wrong parts were used and then an effort was made to correct the mistake. 3 inch...
I believe if you look between the mounting plates you will see a rubber bumper or maybe its disintegrated. It acts as a bumper and shock absorber...
What you can safely do is pinch each hose off "in turn" and see what's affected. You may find that the gates in the heater box don't work after...
Take it back and let them deal with it. You paid to have it done right so it's their responsibility to do just so. Can't be going around behind...
This situation is one of those mystery occurrences that defies explanation. If everything that has to do with efficient cooling has been replaced...
I'm not too sure about the Sniper, but Fitech uses an internal pressure regulator for all it's units so you do not require an external bypass...
After reading all of the above comments, I've come to the conclusion that there are definitely two camps on this subject. It seems many people are...
