Separate names with a comma.
Its bent and squished. Die did not do it.
DaveaLux seems to have one for me.
This is buggered up. Anyone have a spare?
1968 300 pivot shaft
What Big John said.
They have cut out some fat and are usually cheaper. That's all. For a while, I had a "commercial account" at Advance Auto. I...
I had to replace the stub frame (front sub frame) in mine. Apparently, the batteries used to leak and the acid would run into the frame rails...
The spanner ring does not want to move, so I guess I'll just do the seal. That screw idea did the trick! Thanks Big John.
I might just unscrew the spanner nut and see what the inside looks like.
What are you doing with that?
Good idea to use screws.
Having trouble with mine. I have the pulley off. Then the FSM says to thread their special tool into the shaft seal and pull it out. I do not...
Did you just do the seal and o ring or the bearing too?
By the way, that engine is much too clean for 22 years out.
The seal included in the kit is for the shaft, so that will be the same. The O rings included in the kit, seal the reservoir to the pump. All one...
I have a '68 300. Starting my pump rebuild now. Mine is a TRW Large pump w/ the hex. I have just torn it apart. Still need to get the pulley off...
Still cannot figure out how you got that lace to come out so well.
Will there be any other details on the body?
So is this car running yet?
Looks in better condition than when I sent it. Thanks Dana.
I am using Torq Thruster II. 17 x 8. I cannot remember the off set at the moment.
Tires are 245 - 50 - 17
ok. Coming your way. I'll reuse your box.
ok, lets get Dana into this and see what we can do. I'll PM him.
Someone send this boy some parts!
I have the 1968 Holley for that car. Dana, the carb rebuilder mentioned above, built me a new carb using...
oh yea. Nice job saving a classic!
Carbs are not that hard to rebuild. It might be a good experience for you. That is if the carb is still there and rebuildable.
If you go to...